grow 'n up Peter Potty Instrucciones De Ensamblaje

Flushable Toddler Urinal
INSTRUCTION MANUAL
T
hank you for purchasing the Peter Potty Flushable Toddler Urinal for boys. We are confident that you and your child will benefit
®
from its use. To ensure that this potty is of greatest benefit to you, we encourage you to read and follow the instructions carefully
and identify all parts before assembly.
CAUTION:
• Adult Assembly Required. Phillips/cross-head screwdriver is
required (not included).
• Keep small parts away from child during assembly.
• NEVER leave child unattended while using this product.
• NEVER allow children to climb on potty or use as a step stool.
Parts
A
C
B
F
Notes: Illustrations not to scale
Assembling Floor Stand
1. Align the Mount Stand (E) to Stand Lower (F) and
press together.
2. Screw together with two 1 inch (25 mm) long
screws (G).
3. Place potty on a level surface with back of unit
against wall.
4. To adjust height, go to "Mounting Potty Unit &
Adjusting Height." step.
Installing Wall Mount Bracket
1. Choose location to mount potty on wall. Remove Mount Stand (E&F) from back of potty
unit.
2. Determine proper height to mount potty by having child pretend to use and by adjusting height
of potty. Remember the potty is adjustable 4 inches (10 cm) from initial mounting position.
3. Draw a light horizontal pencil line on the wall at the bottom of the potty unit in the
proper height position. Position wall mount vertically 4 inches (10 cm) above the
horizontal line. Mark hole center positions through wall mount. As shown in diagram.
4. Drill two 7/32" (5.6 mm) holes and press anchors (I) in until flush. Mount Wall Mount Bracket
(D) with 1.5" (38 mm) screws (H).
5. To adjust height, go to "Mounting Potty Unit & Adjusting Height." instruction step.
The World's Only
• DO NOT place unit near electrical outlets, appliances, or heaters.
• Tray should be emptied on a regular basis to prevent overflowing.
• Unit should be placed on level floor with back of unit against
wall.
G
Screw - 1" (25 mm)
D
H Screw - 1.5" (38 mm)
FASTENER SHOWN ACTUAL SIZE
E
# DESCRIPTION
A
G
B
C
D Wall Mount
H
E Mount Stand
F Stand Lower
G 1" (25 mm) Screws
H 1.5" (38 mm) Screws
I
I Wall Anchors
E
G
F
Screw - 1.5" (38 mm)
No. 7008
Mounting Potty Unit & Adjusting Height
Ages: 18 mths - 4+ yrs
GB 1. Remove tank and tray from potty unit. (If mounting on the stand, remove wall mount from
the back of the unit by pressing adjustment button down and pulling down on wall mount.)
2. Grab potty firmly by bottom.
3. Assemble the potty unit onto the stand or wall mount by first pressing the adjustment button
and then sliding the potty unit onto the stand or wall mount.
4. Adjust the height of the potty by pressing adjustment button and raising or lowering the potty.
5. Release the button at the desired height. Press down on the potty to insure lock engagement.
Filling Tank
1. Slowly remove tank from the top of the potty unit and allow to drip off.
2. Remove cap as shown in.
3. Fill in sink with clean, cold tap water.
4. Replace cap and place tank on top of potty unit. The tank can be placed
either way.
5. Wait 6-10 seconds for reservoir to fill and potty is ready to use.
Flushing Potty
PARTS LIST
QTY
1. After child uses the potty, push the button to flush.
Tank 1
Hold the button down for 1-2 seconds.
Tray 1
Potty Unit 1 2. Reservoir will fill the flush valve in 6-10 seconds.
1
3. One tank of water will produce 12-15 flushes.
1
1
2
Emptying Tray
2
2
1. Lift up (slightly) on the potty tray handle and slowly pull tray out of the potty unit.
2. Empty tray in to toilet.
3. Rinse, clean, and replace tray into potty unit. Be sure to push tray all the way into the potty unit.
IMPORTANT: Please check the tray and empty on a regular basis to avoid overflow (At least once a day).
Cleaning Potty
1. Wipe tray and potty unit with warm soapy water and dry with a soft dry cloth.
2. If tray overflows, remove potty from stand or wall mount and rinse with warm soapy water in bathtub, shower or utility sink.
Limited Warranty
Screw - 1" (25 mm)
Our products are covered under warranty for a period of 60 days from the date of purchase, under normal use and service, against
defective workmanship and material. If you have recently purchased this product and find it to be defective in anyway, kindly
return it to the "Source of Purchase" for a Full Refund or Exchange.
D
Should the product no longer be covered by your Purchase Receipt, or should you have any questions pertaining to our product,
please call our Toll Free Customer Service for assistance
H
Keep a copy of the UPC Code with proof of purchase receipt for any future Warranty Service.
Please retain packaging and assembly instructions for future reference.
CUSTOMER SERVICE
US & Canada: [email protected]
Toll free hotline: 1-888-468-9898
Other countries: [email protected]
www.grow-n-up.com
Press
® ®
Cozi Beebi and Peter Potty are trademarks of Grow'n Up Ltd.
©2013 Grow'n Up Ltd. All Rights Reserved.
Tsim Sha Tsui, Kowloon, Hong Kong.
MADE IN CHINA.
Press
®