Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
H-4810, H-4811
LOCKER LOCKS
TOOLS NEEDED
7mm Wrench
Figure 1
Figure 2
Figure 3
PAGE 1 OF 3
1-800-295-5510
uline.com
8mm Wrench
INSTALLATION
1. Above the handle on the front of the locker, locate the three
2. Open door. From inside, remove the two nuts and washers
3. To install locker lock, set dial at 0 and remove rear mounting
circular indents. The middle circle will be larger than the top
and bottom circles. (See Figure 1)
holding on the steel plate using a 7mm wrench. Remove the
two bolts from the front. (See Figure 2)
NOTE: For Six Tier Uline Industrial Lockers, steel plate is
attached to door with rivets. To remove, use a power drill
and drill bit to drill out the two rivets holding on the steel
plate.
plate of locker lock. Put rear mounting plate up against the
inside of the locker door and the front of the lock up against
the outside of the door. Push the two pieces together so that
mounting bolts stick out through the mounting plate. Secure
with nuts and tighten using an 8mm wrench. (See Figure 3)
Para Español, vea página 2.
Pour le français, consulter la page 3.
0521 IH-4810
Manuales relacionados para Uline H-4810
Resumen de contenidos para Uline H-4810
- Página 1 7mm wrench. Remove the two bolts from the front. (See Figure 2) NOTE: For Six Tier Uline Industrial Lockers, steel plate is attached to door with rivets. To remove, use a power drill and drill bit to drill out the two rivets holding on the steel plate.
- Página 2 H-4810, H-4811 800-295-5510 uline.mx CANDADOS PARA LOCKER HERRAMIENTAS NECESARIAS Llave de 7 mm Llave de 8 mm INSTALACIÓN Localice las tres muescas circulares ubicadas encima de Diagrama 1 la manija en la parte delantera del locker. El círculo central será más grande que los círculos superior e inferior.
- Página 3 Retirez les deux boulons situés à l'avant. (Voir Figure 2) REMARQUE : Pour les casiers industriels à six rangées Uline, la plaque d'acier est fixée à la porte avec des rivets. Pour enlever la plaque, utilisez une perceuse électrique et une mèche pour retirer les deux rivets la retenant en place.