Drip&Fresh C5190 Manual Del Usuario página 4

Thank you for purchasing this product.
Please, read these instructions before using the timer.
OVERVIEW:
Battery indicator
ON OFF
SEG
ON:
from 3 to 99 seconds from 3 to 99 seconds
LCD display
3/4"
Faucet connector with metallic filter
1"
Manual Button
Automatic adapter
ON / OFF
Increase seconds
Reduce seconds
Pause / Play
Confirm selection
1 - Battery installation.
a.- Remove the front part of the timer by pulling gently.
b.- Remove the 2 screws that hold the battery compartment to the
front part.
c.- Install a 9 V rectangular alkaline battery and screw the
compartment back on. Put the front part back in place and screw
Countdown
the timer to the faucet. The timer's display will turn on with the default
programme. In the event that the battery does not have enough
charge, the indicator in the upper left corner will flash and the timer
will turn off.
SEG
OFF:
BODY
Program Button
Protective cover
LCD MISTING TIMER IN SECONDS
FRONT PART
2- Programming ON and OFF cycles.
Press the 'Prog' button. The number of seconds of the ON cycle
will start flashing. Use the '+' and '-' buttons to choose the number
of seconds you want to keep the timer open and press OK. The
number of seconds of the OFF cycle will start flashing. Use the '+'
and '-' buttons to choose the number of seconds you want to keep
the timer closed and press OK.
3- Operation.
After a few seconds, the timer will let water pass through for the
time set in ON, and will stay closed for the number of seconds set
in OFF, cycling without interruption.
4- 'Pause/Play' button.
Use this button to pause and restart the timer.
Note: This function will not modify the programme.
5- 'Man' button.
Use this button to keep the timer permanently on the ON cycle.
When pressed, the timer will remain open until it is pressed again.
Note water use: water use will depend on the misting nozzles
installed.
6- Turn off the device.
After each use, turn off the timer by pressing and holding the
button for 5 seconds.
7- Switch on the device.
Press the button for 5 seconds. The last programme used will
appear on the display. To change it, follow the steps described in
point 2.
8- Battery life.
Although the timer is designed for an intensive use, battery life will
vary depending on the model (alkaline batteries recommended),
and the ON and OFF cycles set. Shorter cycles require higher
power consumption.
9- Warranty.
This product, according to European regulations, has a 2-year
warranty against manufacturing defects or malfunctions. If the
device does not work properly within the indicated period, contact
the store where you purchased it to use the warranty.
Drip&Fresh
C5190
www.nebulizacion.es