Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
π
H-1886
INDUSTRIAL
LAMINATOR
Before operating the laminator, please review the
following guidelines.
1.
Determine the correct temperature setting for the
pouch you intend to laminate.
2. Set temperature control to the prescribed setting.
NOTE: For first time operation, set the
temperature to the lower end of the
recommended temperature range and test
lamination. If the pouch is not properly sealed,
the temperature can be raised slightly and
the pouch can be reprocessed at the higher
temperature. If the temperature is set too high,
the pouch and/or item being laminated may
be damaged.
3. Turn GREEN POWER switch ON. Allow the laminator
to warm up for approximately ten minutes. Once
laminator's temperature is ready, the AMBER
READY/RUN switch light will begin to blink indicating
the laminator is ready to laminate.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
WARNING! For your protection, do not
connect the laminator to electric power
until you read these instructions.
4. Place the item to laminate into the pouch. Then
place the pouch into the cardboard carrier.
5. Press the AMBER READY/RUN switch ON. The motor will
engage and the rollers will begin turning.
6. Insert the carrier into the front opening of the
laminator. Insert the carrier lengthwise, folded edge
first, straight into the opening.
7. The carrier will exit the rear of the laminator when the
process is completed.
POUCH / TYPE
3 MIL Pouch With Carrier
5 MIL Pouch With Carrier
7 MIL Pouch With Carrier
10 MIL Pouch With Carrier
NOTE: Start at the lowest temperature.
Para Español, vea página 2.
Pour le français, consulter la page 3.
SETTING
#1 to #2
#2 to #3
#3 to #4
#3 to #4
0721 IH-1886
Manuales relacionados para Uline H-1886
Resumen de contenidos para Uline H-1886
- Página 1 Para Español, vea página 2. Pour le français, consulter la page 3. π H-1886 1-800-295-5510 uline.com INDUSTRIAL LAMINATOR WARNING! For your protection, do not connect the laminator to electric power until you read these instructions. INSTRUCTIONS Before operating the laminator, please review the 4.
- Página 2 π H-1886 800-295-5510 uline.mx ENMICADORA INDUSTRIAL ¡ADVERTENCIA! Por su seguridad, no conecte la enmicadora a una fuente de alimentación hasta que haya leído estas instrucciones. INSTRUCCIONES Antes de usar la enmicadora, lea las instrucciones que 4. Coloque el artículo que desea enmicar dentro de se indican a continuación.
- Página 3 π H-1886 1-800-295-5510 uline.ca MACHINE À PLASTIFIER INDUSTRIELLE AVERTISSEMENT! Pour votre protection, ne ARRÊT branchez pas la machine à plastifier dans une prise électrique avant d'avoir lu ces instructions. INSTRUCTIONS Avant d'utiliser la machine à plastifier, veuillez prendre 4. Placez l'article à plastifier dans la pochette. Placez connaissance des lignes directrices suivantes.