Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fax +32 2 359 95 50
•
Put the steam knob (11) in the desired position according to the fabric to iron (see table
above). Set the temperature dial of the iron (9) to the desired position. When the iron has
reached the desired temperature, its pilot light (1) will go out. You can now use the steam
function.
•
As soon as the yellow heating light (14) goes out, press the burst of steam button (8) to
have the steam coming out of the soleplate of the iron. Caution: When you use steam for
the first time, hold the steam button down for about one minute to clean out the steam
producing system. During this operation, you will hear a jerky sound; this is absolutely
normal. Afterwards the steam will come out normally from the soleplate. Every time you
press the steam button, the green pilot light (16) will switch on indicating that steam is
going through the connection cord. When you release the button, the steam will
progressively stop coming out of the soleplate and the green pilot light (16) will go out. If
you want a continuous jet of steam, hold the steam button pressed down.
•
When ironing, the pilot light of the iron (1) will go on and off from time to time. This means
that the temperature of the iron is regulated by its thermostat. You can continue ironing.
•
When you use a lot of steam in a very short time, the steam output is lightly reduced until
your appliance produces enough steam to make up for the difference. This phenomenon
also happens when there is not enough water in the water tank.
•
When the water tank is running empty, you will hear more noise when pressing the steam
button. If you want to go on using the steam function, you will have to refill the water tank.
STEAMING IN A VERTICAL POSITION
You have to hang the garment you want to smooth out avoiding the creases and place the
iron in a vertical position at a few centimetres from the item of clothing. Then move the iron
and press the burst of steam button at the same time.
DRY IRONING
For ironing without steam, put the steam control knob (11) in "OFF" position and do not press
the steam button (8).
WHEN FINISHED IRONING
•
Unplug the appliance and let it cool down.
•
It is not necessary to empty the water tank.
•
We recommend placing the iron on its base when you store it. The foreseen place is non-
slip and will not damage the soleplate of the iron.
ANTI-SCALE CARTRIDGE
•
Your appliance is equipped with an anti-scale cartridge (5) located
inside the water tank (4). As a result, you can use tap water as it will
be filtered by the cartridge.
•
It is necessary to replace the cartridge approximately every 6 months.
However, this period may vary depending on the frequency of use
and on the scale content of the water in your area. If the water
contains much scale, you will have to replace the cartridge more
frequently.
•
To take the cartridge out, remove the water tank as indicated in the
paragraph "Filling the water tank".
•
Then remove the cartridge (5) from the water tank (4) simply by
pulling it out.
•
To buy a new cartridge, please contact the nearest customer
service.
•
Never use the appliances without anti-scale cartridge!
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
13
Assembly page 13/44
special
instruction
from
TKG SIS 9 - 100226
Team
Tabla de contenido
