Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fax +32 2 359 95 50
AUTOMATIC CUTOUT
The automatic cut-off device trips after the iron has been left for approximately eight minutes
in the upright position or unused for approximately thirty seconds in the horizontal position. The
light comes on to indicate that the cut-off device has tripped. As soon as you move the iron,
the device turns off and the iron starts working again.
ANTI-CALC FEATURE
There is a decalcification box inside the appliance, which can absorb unsolvable calcium ion
and send out solvable sodium ion so that water can be softened, and the process of calcium
depositing would be much slower.
•
Your appliance is provided with an anti-scale cartridge situated in the tank.
•
It is necessary to replace the cartridge every six months. However, this period can vary
according to the frequency of use of the iron and of the scale rate in the water of your
region. If the scale rate is high, you will have to change the cartridge more frequently.
•
BEFORE REMOVING THE CARTRIDGE, MAKE SURE THERE IS NO MORE WATER IN THE TANK AND
THAT THE IRON IS COLD.
•
To remove the cartridge, turn the end of the cartridge anticlockwise by a half-round (with
a coin for example) and separate it from the appliance by pulling it out.
•
Introduce a new cartridge in the appliance and turn it clockwise until it stops (see the
mark on the appliance).
•
To obtain a new cartridge, contact the nearest after-sales service.
•
NEVER USE THE APPLIANCE WITHOUT ITS ANTI-SCALE CARTRIDGE.
CARE AND CLEANING
•
Clean the iron regularly according to the hardness of the water and the frequency of use.
•
Fill the water tank and put the thermostat in MAX position.
•
Plug in the appliance. The pilot light will come on. Make sure the steam dial is in
position. Put the iron in vertical position.
•
Never use vinegar or other liquids to descale clean the iron.
•
As soon as the pilot light goes off, hold the iron over a sink and turn the steam dial to the
self-cleaning position
come out of the soleplate.
•
When the water tank is empty, release the steam dial.
•
Unplug the appliance and let it cool down.
•
To clean the plastic parts of the iron, use a humid cloth.
•
To clean the soleplate, make sure you use a product made especially for this purpose.
Never use abrasive products.
WHEN YOU HAVE FINISHED IRONING
•
Turn the temperature dial to "MIN" and unplug the iron from the electrical outlet.
•
With the soleplate facing away from you, turn the iron upside down to empty water.
•
Then store the hot iron on its heel rest so that any remaining moisture will evaporate.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
. Keep the dial in this position. Steam and dust particles will
12
Assembly page 12/48
TKG SI 12 - 091012
Tabla de contenido
