Connect The Poles; Fitting The Safety Guard - sunjoe 24V-GT10-LTE Manual Del Operador

Connect the Poles

1. Connect the poles by inserting the upper pole assembly
into the lower pole assembly (Fig. 5).
Fig. 5
Upper pole
assembly
Pole collar
2. Screw the pole collar on the thread to secure the poles
(Fig. 6).
Fig. 6
Pole collar

Fitting the Safety Guard

m
WARNING!
The safety guard must be properly installed.
The safety guard provides partial protection from the risk of
thrown objects to the operator and other bystanders.
1. Fit the safety guard in the groove on the motor housing,
as shown (Fig. 7).
Fig. 7
Lower pole
assembly
2. Hold the blade hub in place, use the safety guard screw to
fix the safety guard in place, as shown (Fig. 8).
Fig. 8
Operation
The cordless grass trimmer is designed to cut grass and
weeds under bushes, and on slopes that cannot be reached
with the lawn mower. The trimmer must be used outdoors
only, at an ambient temperature between 41ºF (5ºC) and 113ºF
(45ºC).
m
WARNING!
objects from the cutting area. The nylon blade will continue
to rotate for a few seconds after the trimmer is switched off.
Let the motor come to a complete stop before switching the
trimmer back on. Do not rapidly switch the trimmer off and on.
m
WARNING!
into eyes and face, cause blindness, or other serious injury.
Never lean over the trimmer head and always wear eye
protection.
10
Safety guard
Groove
Safety guard
screw
Safety guard
Remove stones, small sticks and other
Rocks or debris may ricochet or be thrown