Satco NUVO S13118 Instrucciones De Instalación Y Seguridad

LED HIGH LUMEN UTILITY LAMP
Models: S13118, S13119
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
• BEFORE YOU BEGIN: Read these instructions completely
and carefully. To avoid personal injury and/or product damage,
all of the instructions below must be followed.
• CAUTION: If the lamp or luminaire exhibits undesirable
operation (buzzing, flickering, etc), immediately turn off power,
remove lamp from luminaire and contact the manufacturer or
distributor.
• WARNING: Risk of fire or electric shock. LED Retrofit Kit
installation requires knowledge of luminaire electrical systems.
If not qualified, do not attempt installation. Contact a qualified
electrician. Installation should be performed only by a qualified
electrician in accordance with Nation Electrical Code and
relevant local code .
• WARNING: Risk of fire or electric shock. Install this kit only
in the luminaires that have the construction features and
dimensions written and shown in the photographs and or
drawings and where the input rating of the retrofit kit does not
exceed the input rating of luminaire.
• WARNING: To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other sharp objects.
• Disconnect power at the source before installation, inspection
or removal. Do not simply switch off fixture.
• This item is rated at 100-277VAC. Installer must determine
whether line voltage 100-277VAC is available at the luminaire
before installation.
• Not intended for use with emergency exit fixtures or
emergency exit lights.
• Not for use with luminaire ballast.
• Do not use if product is damaged.
• This lamp is non-dimmable. Not for use with dimmer.
• Do not make or alter any open holes in an enclosure of wiring
or electrical components during kit installation.
• Risk of fire or electric shock. Do not open or modify. No user
serviceable parts inside.
INSTALLATION:
STEP 1: Turn off the power to the fixture.
STEP 2: Open the fixture's junction box and bypass the HID ballast,
ignitor (if there) and the capacitor (if there) by disconnecting the line
and neutral wires and socket black and white wires in the locations
with "cross" marks in the schematic diagram.Then connect the line to
the black wire from the socket and the neutral to the white wire from
the socket with wire nuts or connectors.
STEP 3: "This luminaire has been modified to operate LED lamps"
shall be marked on the retrofit luminaire where readily visible by the
user during normal maintenance including re-lamping.
STEP 4: Turn on the power to the fixture.
© Copyright 2020 Satco Products, Inc. 5/21
8.63"
(219.2mm)
4.33"
Half open
(110mm)
• Installers should not disconnect existing wires from lamp holder
terminals to make new connections at lamp holder terminals.
Instead, installers should cut existing lamp holder leads away from
the lamp holder and make new electrical connections to lamp
holder lead wires by employing applicable connections.
• Suitable for damp locations. Not for use where directly exposed to
the weather or water.
• Complies with part 15 of FCC. Operation is subject to the following
two conditions: This device may not cause harmful interference,
and this device must accept any interference received including
interference that may cause undesired operation.
• No external weight or mechanical force should be applied to lamp
or components.
• The retrofit assembly is accepted as a component of a luminaire
where the suitability of the combination shall be determined by UL
or authorities having jurisiction.
X X
Ballast
L
Lamp socket
Ignitor
Capacitor
OFF
N
X X
L Wire nut
N
Wire nut
STEP 1 STEP 2
4.33"
Open
(110mm)
7.36"
(187mm)
STEP 3 STEP 4
Satco Products, Inc.
Brentwood, NY 11717