Making Connections - LevelOne WAP-0007 Manual Del Usuario

3. Hard Disk Installation
1. Open the upper cover carefully.
2. Remove the upper cover
3. Insert the 2.5" hard drive into the slot.
Make sure the hard drive connecting pins and the connectors are properly aligned.
4. Put the upper cover back and assemble the cover tightly.
5. Fasten the screw to make sure the hard drive would not loosen.

4. Making Connections

Check TCP/IP settings:
Step 1: Select the "My Network Places" on the Desktop Menu, and click the right button of
mouse to choose the "Properties"
Step 2: Choose the "Properties" of Local Area Connection.
Step 3: Check the "Client for Microsoft Networks", "File and Printer Sharing for
Microsoft Networks", and "Internet Protocol (TCP/IP)" are installed or not. If not, please
install those communication protocols.
Wired Ethernet settings:
Use one Ethernet cable to connect the WAP-0007 and your computer directly. Then follow the
step below to connect the WAP-0007 under the wired Ethernet environment.
Find the Internet Protocol (TCP/IP) Properties from the My Network Places and check the
Properties of Local Area Network Connection. And click the "General" icon and assign one
IP address, which can be from 192.168.123.1 to 192.168.123.253. Here we use the
192.168.123.88 as the IP address. The Subnet mask must be: 255.255.255.0 and the Default
gateway must be: 192.168.123.254. Then click "OK" button to complete TCP/IP setup.
Wireless connection:
Follow the steps below to connect the WAP-0007 in a wireless environment.
Step 1: Enabling the WLAN card first, and check the Wireless Network Connection