Hardware Installation; Wan Connection; Lan / Wireless Lan Connection - Conceptronic C300GBRS4 Manual Del Usuario

ENGLISH
Connect the 3 antennas to the antenna connections on the back of the C300GBRS4.
Connect the power supply to the power connection on the back of the C300GBRS4 and to a free wall
power outlet. The Power LED on the front of the C300GBRS4 will turn on.

3.1 WAN Connection

Use a LAN cable to connect the C300GBRS4 to your Cable, DSL or Fibre Modem.
The WAN LED on the front of the C300GBRS4 will turn on.
Note: If the WAN LED on the front does not turn on, make sure that:
- The C300GBRS4 is powered (the Power LED should burn).
- The Cable, DSL or Fibre Modem is turned on.
- The LAN cable between both devices is correctly connected.

3.2 LAN / Wireless LAN Connection

For LAN Cable Users:
Connect the LAN Cable to 1 of the 4 LAN ports on the back panel of the C300GBRS4 and to the Network
Card of your computer.
The LAN LED of the used LAN port will turn on, indicating that the computer is connected. (Your computer
must be turned on and the LAN Connection must be enabled).
For Wireless Users:
You can connect wireless to the C300GBRS4 in 2 different ways:
- Manually.
- Automatically with the WPS feature.
If you have one or more clients which do not support WPS, it is advised to manually connect to the
C300GBRS4.
Note: The C300GBRS4 is secured with WPA-PSK/WPA2-PSK (mixed mode) by default. The WPA
passphrase for your C300GBRS4 can be found on the productsticker on the bottom of your
C300GBRS4.
In this chapter you will find the steps on how to manually connect to your wireless network.
For more information about the WPS feature and the configuration steps, see Chapter 6 of this Quick
Installation Guide.
30

3. Hardware Installation