Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Lamps: YT-81790, YT-81793, YT-81791, YT-81794
Remove the fixing screws of the cable box cover.
Remove the fixing screws of the stay wire and remove it.
Remove the fixing screw and thread it on the cable.
Introduce the power supply cable to the interior of the housing through the gasket.
Connect the conductors of the cable in accordance with the indications inside the cable box. ATTENTION! It is prohibited to
connect the cable without the protective PE conductor.
Install the stay wire so as to immobilize the power supply cable.
Tighten up the fixing nut and install the cable box cover.
Inspect the conditions of the power supply cable and gaskets and make sure they are in the correct position. In case any defects
of the insulation of the power supply cable are detected, it is required to replace it immediately. It is prohibited to use a lamp with
a damaged power supply cable, since it implies a risk of an electric shock. In case of lamps equipped with a power supply cable,
have it replaced in an authorised repair shop.
Adjustments of the movement sensor
The sensitivity of the sensor is the maximum distance from which the sensor may be activated. Turning the knob marked as
„SENS" clockwise increased the sensitivity, while turning it anticlockwise reduces the sensitivity.
The time for which the device remains active once it has been turned on may be adjusted within the range between 10 +/- 5 sec-
onds to 5+/- 1 minutes. Turning the knob marked as „TIME" anticlockwise reduces the time, while turning it clockwise increased
the time. A movement of the knob towards the symbol „+"increased the time, while a movement towards „-" reduces the time.
Attention! When the light is turned on by the sensor, then each following movement will restart the countdown.
The illumination level adjustment module has a sensor device (a photocell), which detects light and darkness. It is possible to
adjust the operation of the sensor with the knob marked as „LUX". The symbol of the sun indicates that the load will be activated
by the sensor both during the day and at night. The symbol of the moon indicates that the load will be activated by the sensor
solely at night.
ATTENTION! A delayed activation of the load in relation to the moment when the power supply is turned on is normal.
Parameter
Assembly height
Detection angle
Detection range
Delay of time
Grade of protection
SAFETY OF OPERATION
The electric installation of the lamp should be in good working order, and it must be periodically inspected, equipped with adequate
fuses. It should provide electric shock protection through immediate deactivation.
Do not ever use a lamp with visible mechanical damage, a power supply cable with damaged insulation, a broken glass of the
reflector and other visible damage. Any operations related to adjustments and installation must be realised with the power supply
of the lamp turned off.
Do not touch the housing of the reflector, since it heats up during work and may cause burns.
Unit of measurement
O
P
E
R
A
T
GB
[m]
[
]
O
[m]
[s]
I
N
G
M
A
Value
2,5
180
12
10±5 - 300±60
IP44
N
U
A
L
7
Tabla de contenido
