Cable Installation - KS LEV Manual De Instrucciones

Hold the free end of the cable and cable housing to LEV's cable entry point.
Mark this length on the cable and cable housing with a marking pen or
tape.
Using a pair of bicycle cable cutters, trim the cable housing to this measured
length. DO NOT cut the inner wire at this time.
Option 1: Using a standard shifter cable.
Using the cable housing as a guide, cut the inner wire to a length 22mm
longer than the cable housing.
Install LEV's custom barbed ferrule, spring and locking cable end. The inner
cable must not protude beyond the locking cable end which can be
tightended using 2mm and 3mm Hex wrenches.
Option 2: Using Recourse Ultralight cable system
Install LEV's custom barbed ferrule, spring and locking cable end. Route the
Recourse inner wire as shown. Tighten the locking cable end leaving 15mm
spacing as shown. Trim the excess inner wire to be flush with the locking
cable end.

CABLE INSTALLATION

22mm
11
Ferrule
2mm
9
3mm
Spring
Locking Cable End
Cable routing method for
Recourse Ultralight Cable