Rowenta PROVITAL CV8030A0 Manual De Instrucciones página 11

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
NOT CV8010-30 039251
"Classic Volume" diffuser (drawing n°6)
• Curled effect (naturally curly or permed hair), (drawing n°9)
Hold your head down and pass the diffuser through the lengths
and tips.
• Natural volume effect (short or shoulder-length hair)
(drawing n°10)
Apply the diffuser to the root and make circular movements.
5 - CLEANING:
CAUTION: always unplug your appliance before cleaning.
• Your hair dryer requires very little attention. You
can clean it, together with its accessories, using
a slightly damp cloth to remove hair or impuri-
ties trapped in the rear grid.
• Never clean your appliance with alcohol.
• Never immerse your appliance or its
accessories in water.
• Carefully dry all parts you have just cleaned.
6 - ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials
which can be recovered or recycled.
Leave it at a local civic waste collection point.
7 - TROUBLESHOOTING
- Your appliance does not work in the VITAL position:
check that the air speed control is not at 0.
- Your hairdryer stops automatically:
check that the rear grille is not blocked with hair; if this is the
case, take off the removable rear grille and remove the hair.
WIRING INSTRUCTIONS - FOR U.K. ONLY.SAFETY NOTES - FOR REWIREABLE OR MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS 1363 13 A plug. Should the fuse need to
be replaced, a 13 A ASTA approved BS 1362 fuse must be used.
If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded
on plug) and an appropriate one fitted. Warning : dispose of a plug that has been cut from the power sup-
ply cord, as such a plug is hazardous if inserted in a live 13 A socket outlet elsewhere in the house.
Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost
until a replacement is obtained - make certain that only the correct fuse
cover is used and fitted.
For plugs with a detachable fuse cover the replacement must be the
same as the colour insert in the base of the plug, or as directly by
the embossed wording on the base of the plug.
If the detachable fuse cover is lost, a replacement may be purchased
from an approved Rowenta Service Centre (see enclosed Service
Information leaflet). Information for supply may also be obtained
from the plug manufacturer.
U.K ONLY - FITTING A PLUG
Important : the wires in this lead are coloured in accordance with the following codes Blue, Neutral,
Brown, live. Please read the instructions given below before connecting the cord to a plug. If in doubt,
please consult a qualified electrician.
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured mar-
kings identifying the terminals in your plug, proceed as follows :
• the wire which is coloured BLUE must be connected to the terminal which is marked with the letter " N
" or coloured BLACK.
• the wire which is coloured BROWN must be connected to the terminal which is marked with the letter "
L " or coloured RED.
Neither core is to be connected to the earth terminal of a three-pin plug.
This appliance requires a 13 fuse ASTA approved to BS 1362.
7/03/06
9:17
Page 11
GB
Brown
L
or red
Fit correct
Blue or
fuse
N
black
Use cable
gripper
Tabla de contenido
loading

Tabla de contenido