Assembly; Installing / Removing Socket On The Anvil; Operating The Impact Wrench - NORAUTO 46866 Manual De Instrucciones

WARNING Always disconnect impact wrench from the power source before
installing, adjusting or removing any accessory in this tool, or before performing
maintemance. Failure to do so could result in injury.

INSTALLING / REMOVING SOCKET ON THE ANVIL

CAUTION When removing the socket or bit from the tool, avoid contact with
skin and use proper protective gloves when grasping the socket, bit or accessory.
Accessories may be hot after prolonged use.
When installing a socket, align the holes
in the side of the socket with the dent pin.
Press the socket on until the dent pin
engages in the hole.
To remove a socket, pull the socket off the
anvil.
Never tape the trigger switch down to provide continuous high speed. The tool may
fail under such conditions causing fire or personal injury.
Take care when working around a running engine. Run engine in open, well-ventilated
areas ONLY. Running an engine in an enclosed space will allow build-up of carbon
monoxide gas which can lead to dizziness, headaches, vomiting or death.
Keep hair, clothing, cables or wires out of reach of moving parts while the engine is
running.

ASSEMBLY

OPERATING THE IMPACT WRENCH

WARNING
97