Battery Charger; Charging Procedure; Checking The Charger - GreenWorks Tools 29717 Manual Del Usuario

WARNING
·
If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
DO NOT place these batteries in your regular household
trash.
·
DO NOT incinerate.
·
DO NOT place them where they will become part of
·

BATTERY CHARGER

SPECIFICATIONS
40V charger: 2910907
Input: 100-240V AC 50/60Hz, 1.9A Max
Output: 40V DC 2A

CHARGING PROCEDURE

NOTE: The battery is not shipped fully charged. It is
recommended to fully charge before use to ensure that
maximum run time can be achieved. This lithium-ion
battery will not develop a memory and may be charged
at any time.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger (2).
2
English (Original Instructions)
1
3
4
This is a diagnostic charger. The Charger LED Lights (3)
battery status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
False Defect Note:
When the battery is inserted into the charger, and the
for 1 minute, then reinsert. If the status LED indicates
normal than the battery pack is good. If the status LED
is still blinking, remove the battery pack and unplug the
charger. Wait 1 minute and plug the charger back in
and reinsert the battery pack. If the status LED indicates
normal than the battery pack is good. If the status LED is
still blinking then the battery pack is defective and needs
to be replaced.
from the charger and insert again within 2 hours. If the
indictor shows charging, that means the battery is good.
After 2 hours, please pull out the battery and also pull
out the AC power plug of the charger for 1 miniute, and
then insert the AC power plug and the battery again. If the
indictor shows charging, that means the battery is good. If
not, the battery needs to be changed.

CHECKING THE CHARGER

If the battery pack does not charge properly:
·
Check the current at the power outlet with another tool.
Make sure that the outlet is not turned off.
·
Check that the charger contacts have not been shorted
by debris or foreign material.
·
If the surrounding air temperature is not normal room
temperature, move the charger and battery pack to a
location where the temperature is between 7 Û& and Û& .
This product requires assembly.
RED RED
RED
GREEN
ORANGE
RED
OFF
RED
RED
RED
BLINKING