TEFAL PRO MINUTE AQUAPLUS Manual Del Usuario página 9

021472-NOTICE PRO MINUTE AQUAPLUS
A problem with your generator ?
PROBLEMS
The generator does not
come on and the thermostat
light and the on/off switch
are not illuminated.
Water runs out of the holes
in the soleplate.
Water streaks appear on the
linen.
White streaks come through
the holes in the soleplate.
Brown streaks come through
the holes in the soleplate and
stain the linen.
The soleplate is dirty or
brown and may stain the
linen.
3/01/07
• Press the illuminated on/off switch and unplug the generator. Store the electrical
cord in its storage place –
• Raise the retaining hoop over the iron until it locks into place (audible click) –
Your iron is then safely retained on its base. Warning: do not touch the soleplate
while still hot.
• Wind the steam cord around the generator and insert it in its side storage place.
fig.20.
–
• Leave the iron (and the iron rest) to cool down for 30 minutes.
• You can then put your steam generator away, carrying it by the handle –
CAUSES
The appliance is not switched on.
Water has condensed in the
pipes because you are using
steam for the first time or you
have not used it for some time.
The soleplate is not hot
enough.
Your thermostat is faulty: the iron is
not hot enough.
Your ironing board is saturated with
water because it is not suitable for use
with a steam generator.
Your boiler has a build-up of scale
because it has not been rinsed out
regularly.
You are using chemical descaling agents
or additives in the water for ironing.
Fabric fibres have accumulated in the
holes of the soleplate and are burning.
You are ironing at too high a
temperature.
Your linen is not rinsed sufficiently or
you have ironed a new garment before
washing it.
You are using starch.
9:08 Page 7
Storing your generator
fig.19.
SOLUTIONS
Check that your appliance is correctly plugged in
and press the illuminated on/off switch.
Press the steam control button away from your
ironing board until the iron or the brush produces
steam.
Decrease the steam output while ironing at low
temperature (steam output control dial on the
control panel). Wait for the thermostat light to go out
before activating the steam control button.
Contact an Approved Service Centre.
Check that your ironing board is suitable (see page 5).
Rinse out the boiler.
Never add this type of product in the water tank or
in the boiler (see page 5 for what water may be used).
Contact an Approved Service Centre.
Clean the soleplate with a non-metallic sponge.
See our recommendations regarding temperature
control setting.
Ensure linen is rinsed thoroughly to remove any soap deposits
or chemicals on new garments which may be sucked up by
the iron.
Always spray starch on the reverse side of the
fabric to be ironed.
GB
fig.2.
fig.1.
7