Alarm Setting - JBL ON TIME 200ID Manual De Instrucciones

8 8 JBL ON TIME 200
0024CSK - JBLOnTime200iD v12.indd 8 0024CSK - JBLOnTime200iD v12.indd 8
CONTROLS (CONT.)
† †

Alarm Setting

Alarm Setting
1. Press Menu/Up Level at any screen to display Top Menu (may require repeated presses,
depending on which menu state the unit was previously in).
2. Use Up/Down arrows to highlight Alarm. Press Enter to confi rm; or press Alarm to go directly to the Alarm menu.
3. Use Up/Down arrows to select an Alarm slot to edit. Press Enter to confi rm. Hour fi eld becomes highlighted.
4.
Use Up/Down arrows to set Hour. Press Enter to confi rm. Minute fi eld becomes highlighted.
5. Use Up/Down arrows to set Minutes. Press Enter to confi rm. AM/PM fi eld becomes highlighted.
6. Use Up/Down arrows to set AM/PM. Press Enter to confi rm.
7. Use Up/Down arrows to set Day of Week, Weekdays, Weekends, Everyday or One-Time. Press Enter to confi rm.
8. Use Up/Down arrows to set Alarm source. Press Enter to confi rm. Alarm is set!
Note: During alarm-setting, if there is no user input for 2 seconds, display will return to the Now Playing screen. Press any one of the
Enter, Up/Down arrows, or Menu/Up Level to return to setting selection.
Use this same procedure to modify a previously set Alarm.
†
To Enable/Disable a Set Alarm To Enable/Disable a Set Alarm
1. Press Menu/Up Level at any screen to display the Top Menu (may require repeated presses,
depending on which menu state the unit was previously in).
2. Use Up/Down arrows to highlight Alarm. Press Enter to confi rm;
or press Alarm to go directly to the Alarm menu.
3. Use Up/Down arrows to highlight Alarm. Press Alarm to enable/disable the alarm.
An icon will be displayed on the left when the alarm is enabled, and the alarm will sound at the set time.
Waking to the iPod Waking to the iPod
1. Use the steps under Alarm Setting and choose "iPod" as the source.
2. On your iPod, choose the song you would like to awaken to and press Play.
3. Set the volume level on the JBL On Time
4. Put your iPod to sleep by holding down the Play/Pause button (older iPod models may vary).
5. The JBL On Time 200ID system can be put to sleep by pressing the Power button.
Note: If you choose the last song on your iPod, please place the iPod in repeat mode, which will ensure that the iPod will continue playing past the last song.
D USER GUIDE
I
™
200ID unit.
Power
Alarm Source
Preset
Select Up
Menu/Up Level Enter
Select Down
04/09/08 16:26:55 04/09/08 16:26:55