Safety Information - Utilitech Pro MPL1004-LED10K840 Manual De Instrucciones

SAFETY INFORMATION

WARNING
- Use only with a 16-gauge (AWG) extension cord of cord type SW-A, SOW, SOW-A,
STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW-A or SJTOW,
SJTOW-A.
- This product contains chemicals, including lead, known to the state of California to
cause birth defects and other reproductive harm. Wash hands after installing, handling
or otherwise touching this light fixtures.
- To avoid electrical shock, do not use near water or in areas where water may
accumulate. Keep work light at least 16 ft. from pools or spas. Keep plugs dry. Use only
Ground Fault Circuit Interrupter (GFCI) protected receptacles when using this work light
in wet or damp locations. Receptacles are available with built-in GFCI protection and are
to be used for this measure of safety.
- DO NOT handle this fixture or try to plug it in when your hands are wet or when you are
standing on a wet or damp surface or in water.
- Always unplug work light and allow lamp head to cool.
- The work light lamp heads get HOT very quickly. Only touch the power plug or
cushioned handle when turning the lamp heads ON or OFF.
- Do NOT touch the glass lens, wires lens guard or any metal part of the lamp head when
lamp is turned on to avoid burns.
- If exposed skin feels warm while you are in the lighted area, move the work light farther
away. Do not remain in light if skin feels warm.
- Do not look directly at the lighted lamps to avoid eye injuries.
- Always keep the work light away from any flammable materials.
- Unplug and allow lamp to completely cool.
- Do not operate work light if it has a missing or damaged wire guard, lamp containment
barrier or lens cover. Contact customer service for a replacement.
• When using with 12V DC car socket adapter:
- Only insert the plug into a standard 12V DC outlet.
- To reduce the risk of damage to the adapter and cord, pull by the adapter rather than the
cord when disconnecting.
- Make sure the cord is located so that it will not be pulled, twisted, or otherwise subjected to
damage or stress.
Lowes.com
4
OPERATING INSTRUCTIONS
No assembly is required for this work light.
• ON / OFF Switch
- Each work light has an on/off switch. Press the switch toward the marked 120V to turn
work light on. Set the switch back into the center to turn it off.
- Always turn the work light off before unplugging.
• Adjusting the light direction
-
Adjust the lamp head vertically by loosening the two twist knobs on either side of the lamp
head. Adjusting the lamp head to desired position and retighten knobs.
When using with 12V DC car socket adapter:
- Insert the plug into the jack on the work light panel and the other end into a standard 12V
DC car socket outlet.
- Press the switch toward the marked 12V to turn work light on. Set the switch back into
the center to turn it off.
- Always turn the work light off before unplugging.
WARNING: RISK OF PERSONAL INJURY. To avoid being burned, always hold the work
light by its grip handle when making adjustments.
WARNING: RISK OF FIRE. DO NOT aim the work light at flammable or combustible
surfaces.
• Extension cords
- The maximum extension cord length recommended for this work light is 49 in. Use of
extension cords longer than 49 in. can cause a voltage drop that can dim the lights.
- Extension cords used with this work light must have adequate America Wire Gauge (AWG)
or wire size for safe, efficient use. The smaller the gauge of the wire, the greater the
capacity of the wire (e.g., 14-gauge wire has more capacity than 16-gauge wire).
- Use an extension cord or minimum 14-gauge (AWG) 3-conductor or higher capacity such
as 12-gauge or 10-gauge for this work light.
- Always make sure that the prongs on the plug of the extension cord are the same number,
size and shape as those on the work light plug.
- Always be sure that the extension cord is in good electrical condition.
When using with 12V DC car socket adapter:
- Do not use any extension cords when using with DC adapter.
• Storage
- Always allow the work light to cool down completely before storing.
- Store in a safe place, out of the reach of children.
Lowes.com
5