Turntable Installation
a.
Never place the glass tray upside down. The glass
tray should never be restricted.
b.
Both glass tray and turntable ring assembly must
always be used during cooking.
c.
All food and containers of food are always placed on
the glass tray for cooking.
d.
If glass tray or turntable ring assembly cracks or
breaks, contact your nearest authorized service
center.
Hub (underside)
Enamel tray
Turntable shaft
Important information about installing
• This appliance is NOT intended for use in a
commercial environment.
• Please observe the installation instructions provided
and note that this appliance
• should only be installed by a quailed technician.
• The appliance is tied with a plug and must only be
connected to a properly installed earthed socket.
• In case a new socket is needed, installation and cable
connection must only be done by a quailed electrician.
If the plug is no longer accessible following installation,
a pole disconnecting device must be present on the
installation site with a contact gap of at least 3 mm.
• Adapters, multiway strips and extension cords must not
be used. Overloading can result in fire.
• If the appliance is not fitted with a supply cord and a
plug, the connection equipment must have a contact
separation in all poles that provide full disconnection,
and the appliance must be incorporated in the fixed
wiring in accordance with the wiring rules.
Placement
• Danger! Do not disassemble this appliance. Touching
internal components of this appliance can cause
serious personal injury or death.
• Place the microwave oven on a firm, flat surface.
• Make sure that there is sufficient ventilation around the
microwave oven. At the rear and sides keep at least 10
cm free.
• Do not cover the air vents.
• The adjustable feet should not be removed.
• Do not place the microwave oven near a heat source.
• Transmitting and receiving equipment such as radios
and televisions can affect the
• operation of the microwave oven.
The accessible surface may be hot
during operation.
GB
143