nedis UPSD600VBK Manual página 4

Installation & Initial Startup
NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is damaged.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow. Please place the UPS away from other units at least 20 cm to
avoid interference. Do NOT operate the UPS where the temperature and humidity is outside the specific limits. (Please check the specs for the limitations.)
Connect to Utility and Charging
Before initial use, please plug in the AC input cord to the wall outlet and turn on the UPS for charging.
For the best results, suggest to charge the battery at least 8 hours before initial use.
The UPS charges its battery while connecting to the utility with power on.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power switch of UPS unit,
then devices connected to the UPS will be protected by UPS unit.
CAUTION: NEVER connect a laser printer or scanner to the UPS unit.
This may cause the damage of the unit.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the power switch.
Indicators & Alarm Table for Operation
Conditions
AC mode
Battery mode
Low battery at battery mode
Fault
Alarm for overtemperature protection
Visual Indications
Green LED lighting
Green LED flashing every 10 seconds
Green LED flashing every second & Red LED lighting
Red LED lighting
Red LED flashing every 0.5 seconds
Alarm
Off
Sounding every 10 seconds
Sounding every second
Continuously sounding
Off
3