Sthor 78873 Manual De Instrucciones página 12

GB
to the socket on the vacuum cleaner, make sure that both devices are switched in the off position.
After connecting a vacuum cleaner to dust extraction outlet of the electric tool (to do so you may need an adapter, which is not
equipped with the vacuum cleaner), and the plug of electric tool to socket of vacuum cleaner, you can start vacuum cleaner by
switching the switch in position "I", vacuum cleaner will start its operation independently of the electric tool operation and will run
until the switch is not switched to position "O".
The automatic mode of operation is preferred. For this purpose, after connecting a vacuum cleaner to dust extraction of electric
tool, and tool plug to socket on vacuum cleaner, you should move the switch to position "II". The vacuum cleaner turns on auto-
matically after a short time from starting of the electric tool and turns off automatically also after a short time after switching off
power supply for the tool.
Regardless of the selected operating mode, after finished work, turn off the vacuum cleaner by switching the switch in position "O", then unplug the vacuum cleaner from the mains socket, plug of electric tool unplug from the vacuum cleaner and proceed
to maintenance.
Note! If during the operation there will be observed suspicious vibration, drop in suction, or you will hear the louder engine opera-
tion, it may mean the filling of tank or clog of hose or suction nozzle. In this case, immediately turn off the vacuum cleaner by the
switch and unplug the power cord from the mains socket. Then empty the tank and check for obstruction in the hose and nozzle.
If necessary unblock. if unblocking the hose or suction nozzle is not be possible, they must be replaced for a new one before
further work.
Note! If you use a vacuum cleaner as a blower, make sure that the tank has been emptied of all debris, and the filter cleaned or
replaced. There is a risk of suction of impurities accumulated in the reservoir through the inlet.
Maintenance of the vacuum cleaner
Note! Before any maintenance activities, make sure that the power cord is disconnected from the mains socket.
After each use of a vacuum cleaner, check the tank, lid seal, and air filter as it is described in the Section: "Preparing for opera-
tion".
Clean the vacuum from the outside with a jet of compressed air, of pressure of not more than 0.3 MPa. Particular attention should
be paid to the patency of the ventilation holes, both inlet and exhaust. If needed, clean it by compressed air of pressure not more
than 0.3 MPa. Do not use sharp metal objects to clean the vents. Do not immerse the cleaner in water to vacuum clean it. Vacuum
cleaner hose must be checked before and after each use for damage. It is forbidden to use a damaged hose. In case of intake of
water or wet dirt, you should clean the inside of vacuum cleaner, flexible hose, extension tubes and nozzles immediately after use.
Dried dirt can lead to irreversible damage to the vacuum cleaner or its components.
The interior of the hose and extension pipes should be cleaned with a jet of water, then leave to dry completely.
Larger dirt from the housing should be removed with a soft cloth.
O R I G I N A L I N S T R U C T I O N S
12