• The transmitter module must not be
co-located with any other transmitter
or antenna, except in accordance
with FCC/IC multi-transmitter product
procedure. The OEM integrator is
responsible for ensuring compliance
with the applicable FCC/IC rules for
the transmitters operating individually
and simultaneously, and
• The transmitter module must use only
the approved antennas listed below:
- Chip antenna, 4.61 dBi
- Dish antenna, 34.1 dBi
- Panel antenna, 23 dBi
IMPORTANT NOTE:
It is necessary that the system
integrators perform all applicable
retesting and certification for their
final system configurations.
The final system should be re-tested
for FCC/IC unintentional emission
testing. In the event that the conditions
outlined above cannot be met,
then the FCC/IC authorization of
this module is no longer considered
valid and the FCC/IC ID cannot be
used on the final system. In these
circumstances, the OEM integrator will
be responsible for re-evaluating the
final system (including the transmitter)
and obtaining a separate FCC/IC
authorization.
