Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Dear customer, thank you for purchasing our product.
PLEASE
READ
INSTALLATION AND FIRST USE OF THE WATER HEATER.
The water heater has been manufactured in compliance with the relevant standards
and tested by the relevant authorities as indicated by the safety certificate. Basic
technical characteristics of the product are listed on the label attached to the
protective cover. The installation of the water heater must be carried out by qualified
staff only. All repairs and maintenance work in the interior of the water heater as
well as limestone removal or testing/replacement of the corrosion protection anode
may only be carried out by an approved maintenance service provider.
The water heater has been manufactured so as to allow alternative sources of
energy to be used, as follows:
- central heating hot-water system
- solar power
- heating pump.
INSTALLATION
The heater should be installed in a dry room that is not subject to freezing conditions,
preferably in the vicinity of other sources of heating (e.g. boiler room).
TECHNICAL CHARACTERISTICS
Heater volume
Total mass
Rated pressure
PT heated surface – lower
PT heated surface – upper
PT volume – lower
PT volume – upper
Type
H
ΦD
A
KGV 400-2 1835 670 320 880 1000 1100 1460 345 1000 1521 910 1490 560 370 Φ33x750
KGV 500-2 1853 750 370 930 1095 1195 1465 370 1095 1498 960 1465 560 310 Φ33x850
PT - heat exchanger
28
THE
INSTRUCTIONS
[ MPa ]
Size in mm
B
C
E
F
CAREFULLY PRIOR
KGV 400-2
[ l ]
385
[ kg ]
158
[ m
]
1,8
2
[ m
]
2
[ l ]
11,3
[ l ]
G
I
J
K
TO
KGV 500-2
500
172
1
2
1
12,6
6,3
Length of
anode in
L
M
N
mm
THE
Size of
slope in
mm
1930
1970
Tabla de contenido
