Conceptronic Grab'n'GO CHD2UES Guia De Inicio Rapido página 6

ENGLISH
3. Hardware Installation CHD2UES
3.1 Assembling the CHD2UES (When no hard disk is installed yet)
If you bought the CHD2UES with a hard disk pre-installed, you can skip this step and
continue to step 3.2
a. Gently slide the hard disk tray out of the back of the housing.
b. Remove the bag with the 2 assembly screws and HDD foam from the housing.
c. Connect the 2,5" hard disk gently to the connector. Make sure the connector is
connected correctly to the hard disk.
d. Stick the included foam on the bottom of the harddisk, before you place the
harddisk in the housing.
e. Slide back the tray in the housing.
f. Use the 2 delivered screws to secure the tray in the housing.
6