Conceptronic Grab'n'GO CHD3UL Guía De Instalación Rápida página 7

ENGLISH
3. Hardware Installation CHD3UL
3.1 Assembling the CHD3UL (When no hard disk is installed yet)
If you bought the CHD3UL with a hard disk pre-installed, you can skip this step and
continue to step 3.2
a. Remove the 2 screws at the back of the CHD3UL and remove the back plate.
b. Gently slide the hard disk tray out of the housing.
Note: You need to set your hard disk to 'Master' or 'Single', depending on the
type of hard disk you are using. How to make this setting is indicated on
your hard disk itself or in its manual.
c. Connect the power and IDE cable to the hard disk and place the hard disk in the
tray.
Note: Make sure that the screwholes of the harddisk are aligned with the
notches of the tray. In some cases the IDE cable must slide partitially
under the electronic board before you can continue the assembly.
D
7