JET J-A3816 Manual De Instrucciones De Operación Y Piezas página 5

25. A guard or other part that is damaged should be
properly repaired or replaced.
26. Do not leave tool running unattended. Turn
power off. Don't leave tool until it comes to a
complete stop.
27. Make certain the switch is in the OFF position
before connecting the machine to the power
supply.
28. Make certain the machine is properly grounded.
29. Give your work undivided attention. Looking
around, carrying on a conversation and "horse-
play" are careless acts that can result in serious
injury.
30. The operator should not wear gloves when
operating the machine.
31. All doors should be closed, all panels replaced
and other safety guards should be in place prior
to the machine being started or operated.
32. Be sure the drill bit is not in contact with the
work piece when the motor is started. The motor
should be started and up to full speed before
bringing the drill bit into contact with the work
piece.
33. Keep your hands away from the drilling area.
34. The drill press must be stopped and the
electrical supply must be cut off before any drill
bit replacement or machine adjustment is done,
or before any attempt is made to change the
drive belts or before any periodic service or
maintenance is performed on the drill press.
35. Remove loose items and unnecessary work
pieces from the area before starting the
machine.
36. The work piece must be securely clamped
before the drill bit comes in contact with the work
piece.
37. The drill press must be stopped and the
electrical supply cut off or machine unplugged
before reaching into the drilling area.
38. Wear eye protection.
39. Do not remove jammed pieces until motor has
stopped.
40. Hold workpiece firmly against table.
WARNING: This product can expose you to
chemicals including lead and cadmium which
are known to the State of California to cause
cancer and birth defects or other reproductive
harm, and phthalates which are known to the
State of California to cause birth defects or
other reproductive harm. For more information
go to http://www.p65warnings.ca.gov.
WARNING: Some dust, fumes and gases
created by power sanding, sawing, grinding,
drilling, welding and other construction activities
contain chemicals known to the State of
California to cause cancer and birth defects or
other reproductive harm. Some examples of
these chemicals are:
• lead from lead based paint
• crystalline silica from bricks, cement and
other masonry products
• arsenic and chromium from chemically
treated lumber
Your risk of exposure varies, depending on how
often you do this type of work. To reduce your
exposure to these chemicals, work in a well-
ventilated area and work with approved safety
equipment, such as dust masks that are
specifically designed to filter out microscopic
particles. For
http://www.p65warnings.ca.gov/ and http://www.
p65warnings.ca.gov/wood.
5
more information go to