Tabla de contenido
INSTRUCTION MANUAL
DIRECT CLIP-ON MODE:
• Selecting direct clip-on mode provides power to the
black and red input leads.
• Select LO-F or HI-F .LO-F is used for deep (and,or) long traces.
HI-F is used for shallow and/or short traces.
• LO-F Mode - Adjust power output selector arrows to increase the power
to a visible level on the bar graph. It is best to start with a low level
signal indicated by an "OK" near the power output bar.
Note: If "OK" does not appear, turn off transmitter and
re-locate ground stake.
ON
Level 1
EXT
PWR
Hi-F
Power
Lo-F
OK
Done
Track
• Soil conditions affect the effectiveness of the ground.
• HI-F Mode - Select power level 1-4 to give the best response
WARNING
DO NOT TOUCH THE METAL RED OR BLACK ALLIGATOR CLIPS ON THE
TRANSMITTER CORDS WHEN THE POWER IS ON, INJURY OR DEATH MAY OCCUR.
BROADCAST OR CLAMP
When using one of the two connectionless modes, select "Broadcast or Clamp" from the
Home screen. This turns on transmitter power to the Broadcast antenna in the bottom of
the case. The case then can be positioned over a wire or metal pipe to induce a tracing
signal in it. If the Inductive Clamp is plugged in to the front panel in the mode it becomes
the active antenna and can be used to induce tracing signals on many wires and pipes
by clamping the jaws around the target.
Broadcast
or Clamp
EXT
PWR
ON
Done
I
8
KING INNOVATION
KING 900 RECEIVER
LCD DISPLAY
ON/OFF
CONTROL
SETUP
• Turn on receiver. The ready screen will be shown.
READY
PASSIVE AC
Change
Setup
Start
Press F2 - Setup and use the arrows to scroll
through the following options:
• Power Down: allows user to select the amount of time before the unit will
automatically shut off to save battery power.
POWER DOWN
ON, 15 MIN, 30 MIN, 60 MIN
KING 900
MODE
CONTROLS
ADJUSTMENT
CONTROLS
HEADSET
JACK
I
KING INNOVATION
9
Tabla de contenido
