Idiomas disponibles
Idiomas disponibles
Old Upper
Baffle
Figure 3: Installation of New Upper Baffle
Upper
Baffle
Lower
Baffle
Figure 4: Removing knockout and
attaching Lower Baffle
Back
Panel
Baffle
Blower
Blower
Outlet
Figure 5: Front of Heater, Attaching
8.
Position blower assembly on cabinet back
panel with inlet over slots in panel,outlet
pointed towards front (see Figure 5).
9.
While holding blower against inside of
back panel, attach blower with two #10
screws (suppllied) as shown in Figure 5).
10.
Attach blower switch to upper baffle with
two #8 screws see Figure 5.
2
ATTAChING bLOweR ACCeSSORy
Screws
Slots
Fan
Switch
Power Cord Placement
blower
www.fmiproducts.com
Continued
11.
Reattach front panel to heater using four
painted screws removed in step 1.
12.
Complete installation of heater by follow-
ing the steps in your owner's manual.
WALL MOUNTING
INSTRUCTIONS FOR
MODELS WITH MOUNTING
1.
Mount heater to wall by following steps
under Installing to wall in owner's
manual.
2.
Plug power cord of blower into grounded
outlet.
EXTENSION CORD
Use extension cord if needed. The cord must
have a three-prong, grounding plug and a
three-hole receptacle. Make sure cord is in
good shape. It must be heavy enough to carry
the current needed. An undersize cord will
cause a drop in line voltage. This will result in
loss of power and overheating. Use a No. 16
AWG cord for lengths less than 50 feet.
CAUTION: Verify proper op-
eration after servicing.
BLOWER OPERATING
The blower is connected to a thermostat. When
unit heats up, the blower will operate. A few
minutes after unit cycles off or is turned off,
blower will shut off. Blower will cycle on and
off in this manner. Note: If you have a heater
with a thermostat, the heater and blower will
not turn off and on at exactly the same time.
Blower cycle times will vary with heat setting
selected.
110/115
V.A.C.
Black
Green
White
Figure 6: Wiring Diagram For Blower
BRACKETS
Thermostat
Sensor
Switch
Black
White
Green
Accessory
Blower
Motor
125626-01A
