Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Steps
Position brackets so that the top bracket hole slides
over the bolt plate stud. Install M12 nut with lock and
flat washer to secure bracket to vehicle. Do not fully
6
Repeat Steps 6 and 7 for remaining (2) driver side
bracket locations. (Driver side rear bracket shown)
8
Repeat Step 19 to attach the nerf bar at the middle and
10
NOTE: Actual application may vary slightly from illustrations.
tighten at this time.
rear bracket locations.
Install M10 bolt with lock and flat washer in the lower
bracket hole, by threading the bolt into the welded nut of
the bolt plate. Do not fully tighten at this time.
7
Align the passenger side nerf bar with the passenger
side front mounting bracket and loosely attach using
(2) 8mm x 25mm bolts, (2) 8mm lock washers, and
Bolt, lock
washer, and flat
9
washer
Check boards for final position and tighten all bracket
hardware to 40 lb-ft. Repeat Steps 1-9 for passenger side.
11
Page 3 of 4
(2) 8mm x 24 mm flat washers.
Nerf bar
Tabla de contenido
