Lee Stafford Blow & Go Manual Del Usuario página 6

Tabla de contenido
EN
KEY FEATURES:
• 1800W high power DC motor
• Coconut Keratin conditioning system smooths frizz and
maximises hair softness and shine
• 3 heat & 2 speed settings for ultimate control
• Includes two fast dry nozzles & air wand attachments
• Includes cool shot to set your style
• Removable easy clean rear grille
• 3m soft, flexible power cord
• UK/EU plug adaptor
OPERATING INSTRUCTIONS:
• To use the dryer with the styling concentrators, ensure
the dryer is switched off then attach the concentrator
by gently sliding it onto the dryer barrel until it is secure,
plug in to the mains and turn on by using the speed
switch on the handle. Use a low heat and speed setting
when using the concentrators.
• To use the dryer without the styling concentrator, plug
in to the mains and turn on by using the speed switch on
the handle.
• Adjust the heat and speed switches on the handle to the
desired setting (higher heat and speed settings for drying
and; lower heat and speed settings for styling).
• To use the cold shot, press and hold the button at the
front of the hairdryer. This will cool the hair and help to
set the style.
• After use, switch the speed setting to 0 to turn the
hairdryer off.
STYLING INSTRUCTIONS:
Blow-drying with a brush to create volume (brush not
included):
• Apply a heat protection spray/serum to towel dried hair
to help protect your hair from heat damage.
• Divide and clip the hair into several neat sections
2-4inches wide (preferably the same width as the brush
you will be using).
• Select and lift hair up and place hairbrush at root
allowing hair to fall over the brush.
• Anchor the section of hair being dried with the brush
and hold the dryer so that the airflow is directed down
the hair shaft from root to tip. Move the brush and dryer
together down the hair shaft to the hair ends.
• Press and hold the cool shot button to cool down the
section and set the style.
Using the Air Wand to create curls and texture:
• Follow the first 2 points as described above:
• Ensure the dryer is switched off. Lift hair section and
place styling wand at the roots.
• Carefully wind the hair section around the wand. Use a
low/medium heat speed to gently help form the curl.
• Press and hold the cool shot button to cool down the
section and set the style. Finish the style using your
fingers to create the desired look.
CLEANING AND MAINTENANCE:
To maintain peak product performance and to prolong
motor life, it is important to regularly remove dust and
dirt from the rear grille and clean.
To remove – Turn the rear-grille anti-clockwise (as
marked on the grille) and pull out.
To clean – Pull out the black filter from the centre, clean
with a soft brush and replace.
To replace – Align the grille guides with the slots in the
casing (on the dryer) and turn clockwise.
SAFETY CAUTIONS:
WARNING – FOR ADDITIONAL PROTECTION
THE INSTALLATION OF A RESIDUAL
CURRENT (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING
30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR
ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN
INTO A BATHROOM, IT SHOULD NOT BE USED NEAR
BASINS OR OTHER VESSELS CONTAINING WATER.
THE HAIRDRYER SHOULD BE UNPLUGGED FROM
MAINS SUPPLY WHEN NOT IN USE.
Do not leave the dryer unattended when switched on.
Allow the dryer to cool down before storage.
Do not immerse in water or other liquids.
Do not wrap the cord around the unit. Check cord
regularly for any sign of damage. Damaged cords can be
dangerous.
In use, take care that the inlet and outlet grilles are
not blocked in any way as this will cause the unit to
automatically stop. Should this occur, switch off and
allow the unit to cool down. Ensure the inlet grille is free
from obstructions such as household fluff, loose hair etc.
Do not place hairdryer on soft material e.g. carpet,
bedding, towels, rugs etc.
Do not leave the dryer switched on when you set it down.
Always ensure the voltage to be used corresponds to the
voltage stated on the unit.
Do not direct the airflow towards the eyes or other
sensitive areas.
Keep this product out of reach of children. The use of this
appliance by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their
safety should give explicit instructions or supervise the
use of the appliance.
Do not use any attachments with this hairdryer, other
than those supplied by Lee Stafford.
Avoid allowing any part of the hairdryer to contact the
face, neck or scalp.
If the supply cord of this unit becomes damaged,
discontinue use immediately and return the appliance to
your nearest authorised Lee Stafford service dealer for
repair or replacement in order to avoid a hazard.
Special tools are required for any examination,
adjustment or repair. Unqualified repair work could lead
to hazardous conditions for the user.
Tabla de contenido
loading

Tabla de contenido