Important Notice - AMS VICAM--CAMPAL Manual Del Usuario

Model/Type reference:
VICAM-AMS-CAMPAL, VICAM-AMS-CAMPALB1, VICAM-AMS-CAMPALB2, VICAM-AMS-CAMPALBS, VICAM-
AMS-CAMPALD, VICAM-AMS-M7-12V, VICAM-AMS-M7P4-12V, VICAM-AMS-MS7-12V, VICAM-AMS-M9-12V,
VICAM-AMS-M9P4-12V, VICAM-AMS-MS9-12V, VICAM-AMS-M7WP-12V, VICAM-AMS-M5-WP
FCC LABELLING AND INSTRUCTION MANUAL REQUIREMENTS
Devices subject to FCC Part 15, Subpart B verification (not certification) must be labelled with the
following statement. The label can be affixed at any space external to the product except the battery
door or detachable parts.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
In addition, the instructions furnished the user shall include the following or similar statement, placed
in a prominent location in the text of the manual:
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
For a Class B digital device or peripheral, the instructions furnished the user shall include the following
or similar statement, placed in a prominent location in the text of the manual:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
If shielded cables of other specialized accessories are necessary for the unit to achieve compliance, a
statement similar to the following should be added:
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
2
AMS Diffusion - Rue des Galeries - ZA du Chevalement - 59286 Roost Warendin - FRANCE - Tél. +33 (0)3.27.94.44.44 - Fax. +33 (0)3 27 94 44 45
Email : [email protected] - www.ams-diffusion.com RCS DOUAI A 451 360 382 - CODE APE 4531Z - SIRET 451 360 382 00035 - TVA FR 55 451 360 382
FCC 1. PACKAGE CONTENT
7" or 9" screen
VICAM-AMS-M7-12V
VICAM-AMS-M9-12V
VICAM-AMS-MS7-12V
VICAM-AMS-MS9-12V
VICAM-AMS-M7WP-12V
VICAM-AMS-M5-WP
Articulated stand
monitor
VICAM-AMS-PM
20m extension cable
VICAM-AMS-CR20

IMPORTANT NOTICE

- We recommend that you have your equipment installed by a professional (cf. disclaimer section).
Failure to observe the instructions might result in damage to material and affect the proper functioning of the device. It
might also compromise people's safety. AMS will not assume responsibility if these instructions are not followed.
- Installation of the monitor :
Be careful not to disturb usual operations and the driver's visibility.
-Installation of the camera(s) :
Position your camera so as to avoid impact. Check the positioning of the sun visor and the slope of the camera.
Avoid attaching your camera to vibrating parts.
- Connection of the cables :
Before doing any work on the electrical components of your device. Always disconnect the negative terminal of the battery
(and possibly the spare battery too) to avoid any risk of short circuits. On disconnecting the negative terminal of the
battery, the volatile memories of the convenience electronics will lose their stored data.
AMS Diffusion - Rue des Galeries - ZA du Chevalement - 59286 Roost Warendin - FRANCE - Tél. +33 (0)3.27.94.44.44 - Fax. +33 (0)3 27 94 44 45
Email : [email protected] - www.ams-diffusion.com RCS DOUAI A 451 360 382 - CODE APE 4531Z - SIRET 451 360 382 00035 - TVA FR 55 451 360 382
120° Camera
VICAM-AMS-CAM-PAL
Remote control
VICAM-AMS-RM-WL
Power-supply cable
M7/M9/M7WP/M5-WP :
VICAM-AMS-FM7-13
MS7/MS9 :
VICAM-AMS-FMS7
VICAM-AMS-FMCS7
3