Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10. ROUTING WITH PARALLEL GUIDE (SEE FIG.
H, I)
Slide the parallel guide (25) with the guide rods (26)
into the base plate (9) and tighten at the required
measure with the locking screw (11).
Guide the machine with uniform feed and sideward
pressure on the parallel guide along the edge of the
workpiece.
25 26
H
I
11. ROUTING CIRCULAR ARC PROFILES
(SEE FIG. J, K)
• Reverse the parallel guide (facing surfaces
point upwards) and insert the guide rods into
the base plate. Fasten center pin (27) to parallel
guide (through hole) with wing bolt (28).
• Puncture center pin into marked centre of the
circular arc and guide router with consistent feed
across the workpiece surface.
28
27
J
K
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all
working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This
is normal and will not damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling
advice.
39
Tabla de contenido
