Desa W32LT Instrucciones De Instalación página 4

5. Position fireplace inside mantel (see Figure 6). Care-
fully position gas lines. IMPORTANT: Use caution when
positioning fireplace on base. Base may scratch easily.
Make sure fireplace is in proper position within mantel
opening before continuing with installation.
6. Fireplace with louver door: Lower bottom louver door.
Use two screws provided in hardware package and attach
fireplace to wooden base. Close louver door
Fireplace with fixed louver: Before installing logs or
burner assembly (see owner's manual) remove screws
securing floor to assembly. Lift floor for access to bot-
tom of fireplace. Use two screws provided in fireplace
hardware package and attach fireplace base to wooden
base. Reinstall floor with screws removed previously.
7. If mantel trim that came with your fireplace has not yet
been assembled, see Assembling Perimeter Trim. Place
metal trim on shoulder screws. Firmly snap trim assembly
over shoulder screws on fireplace.
8. Carefully push mantel and base into position against
wall.
Figure 6 - Installing Fireplace
AssemblING PeRImeteR tRIm
with Gas Fireplace)
1. Remove packaging from three pieces of metal trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 7.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 7).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 7).
6. While firmly holding edges of trim together, tighten both
set screws on the adjusting plate with slotted screw-
driver.
7. Repeat steps 2 through 6 for other corner.
Set Screws
Adjusting
Plate
Shim
DESA Heating, LLC
2701 Industrial Drive
Bowling Green, KY 42101
www.desatech.com
1-866-672-6040
Slot
Slot
Figure 7 - assembling trim
(If supplied
Top Trim
Mitered Edge
Side Trim
119494-01
Rev. C
08/08