Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BASEMENT SENTRY CONTROLLER FUNCTIONS
There are two buttons on the front of the controller.
1. Silence/Reset - Can be pressed to silence current
alarms for 24 hours.
Can be held for 3+ seconds to reset (or clear) alarms
and LEDs. Flashing LEDs for conditions such as bad/
disconnected battery or power outage, for example,
can't be cleared by Silence/Reset. These conditions
must be resolved to eliminate the LED indicator.
2. Test - Will run the pump to determine if amp draw of
pump is within range.
Controller is factory programmed to self-test the pump
for several seconds every 7 days. This schedule may
be modified once the controller is connected to the Z
Control Cloud.
Pressing the test button will start the 7 day timer for
self-testing.
Test and Silence/Reset -
Holding both buttons together for about six seconds
will initiate a factory reset. This returns the firmware's
device configuration to the state in which it left the
factory. Any over-the-air firmware updates that have
been installed will be retained.
BASEMENT SENTRY LED LIGHT FUNCTIONS
AC
AC
AC
FLOAT
POWER
POWER
POWER
STATUS
DC
BATTERY
BATTERY
BATTERY
PUMP
9
© 2020. All rights reserved.
1
P L U S
AC
FLOAT
POWER
STATUS
24/7 BASEMENT
PROTECTION
BATTERY
PUMP
USB
1-800-584-8089
DC
BasementSentry.com
RESET
FLOAT
PUMP
2
P L U S
AC
POWER
24/7 BASEMENT
PROTECTION
BATTERY
USB
1-800-584-8089
BasementSentry.com
RESET
FLOAT
AC
FLOAT
POWER
STATUS
DC
BATTERY
PUMP
by
TEST
DC
Silence/
Reset
SILENCE
DC POWER
+ 15V DC 1.6A
FUSE
30 AMP
by
Test
FLOAT
STATUS
TEST
DC
PUMP
SILENCE
DC POWER
+ 15V DC 1.6A
DC
FUSE
PUMP
30 AMP
Tabla de contenido
