Uline H-1551 Manual Del Usuario

π
H-1551
ULINE HEAVY-DUTY
SNAP-BLADE KNIFE
TOOL NEEDED
Pliers (optional)
OPERATION
1. Advance blade extender button until one blade
segment is exposed.
2. When finished using knife, retract blade into handle.
3. When blade segment in use becomes dull, use a
pair of pliers to snap segment off. There are eight
blade segments per sheet.
NOTE: When on the eighth blade segment, be
sure not to advance the blade extender too far.
If the button is advanced to the correct spot,
just the tip of the blade will show. (See Figure 1)
If pushed too far, the knife enters blade release
mode and the blade falls out. (See Figure 2)
Figure 1
Blade Extender
Button
Blade
Operation Mode
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
BLADE REMOVAL
1.
2. Retract the blade extender button as far back as it
ADDING NEW BLADES
1. To add blade sheets to the knife, push red button
2. Insert up to six blade sheets into front of cartridge,
3. Push the cartridge back into knife handle.
4. Retract the blade extender button as far back as it
Pour le français, consulter les page 3.
When a sheet of blades is completely used,
advance the blade extender button as far as
possible to front of knife to enter blade release mode.
Grab the tip of the sheet and pull it out. (See Figure 2)
Figure 2
Blade Extender
Button
Front
Blade
Blade Release Mode
will go to catch a new sheet.
on end of handle and pull blade cartridge out of
handle.
one at a time.
will go to catch a new sheet.
Para Español, vea página 2.
0621 IH-1551