Instruction Manual - VERTO 52G500 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
GB
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
GARDEN VACUUM CLEANER
52G500
CAUTION: BEFORE USING THE POWER TOOL, READ THIS MANUAL
CAREFULLY AND KEEP IT FOR FUTURE REFERENCE.
DETAILED SAFETY REGULATIONS
SPECIFIC REQUIREMENTS FOR ELECTRIC MAINS POWERED LEAF
BLOWERS
WARNING: Observe safety regulations when using the device. For
your own safety and that of other people, please read this manual
before starting work. Keep the manual for future reference.
Instruction
• Before use, unwind the power cord and check it for signs of damage
or wear.
• Do not use the device if the power cables are damaged or worn out.
• Before connecting to the power source, always make sure the supply
voltage is compatible with the value specified on the nameplate of
the tool.
• Connect the device only to electrical system equipped with residual
current circuit breaker that will cut the power off when earth leakage
current exceeds 30 mA in less than 30 ms.
• To connect the tool, use a power cord suitable for use outdoors.
• Disconnect the power immediately if the power cord is damaged
during operation. DO NOT TOUCH THE POWER CORD before
disconnecting power supply.
• WARNING. The turbine keeps on turning after the motor is stopped.
• Keep the unwound power cord away from the suction tube.
• Do not allow the tool to be operated by children and people not
familiarized with the operating instructions.
• Stop working when other people, especially children or pets are
nearby.
• REMEMBER. The operator / user is responsible for accidents or
hazards occurring to other people or the environment.
Preparation
• Always wear sturdy shoes and long trousers during operation.
• Do not wear loose clothing that can be sucked into the suction tube.
Keep long hair away from air intakes.
• Always use personal protective equipment like safety glasses and
hearing protection.
• Check thoroughly the area where you are going to work and remove
all items that can be sucked into the suction tube or rejected by a blow
from the air blower.
• Do not begin working without air tubes, safety devices and covers
installed in place.
• Hold the tool with both hands so the end of the pipe is not obstructed
by the ground.
• Attach the extension cord in the handle so that its accidental
disconnection is impossible.
Use
• Work only in daylight or good artificial light.
• Avoid wet leaves and water being sucked in.
• Always make sure that your legs stand firmly on the slope.
• Walk, never run.
• Use particular caution when changing direction of sucking / blowing
leaves.
• When moving the tool, turn it off.
• Do not use the tool, if the safety guards or protective covers are
damaged or not attached.
• Make sure the vents are not clogged by dirt or debris.
• Before starting the tool, make sure that you are firmly holding the tool
handle with both hands.
• Pull the plug out of mains socket:
– every time you walk away from the device;
– before checking, cleaning or repairing the device;
– after the device has been struck by a foreign object - check if it is
not broken;
– if it begins to vibrate excessively;
• Repairs to the tool should only be made by authorized personnel.
• Use only original parts recommended by the manufacturer.
Maintenance and storage
• Keep all components in good condition to make sure that the tool will
work safely.
• For safety reasons, replace worn or damaged parts.
• Protect the tool from moisture.
• Keep out of reach of children.
Explanation of pictograms used
1
2
6
7
11
12
1. Read all instructions
2. Use safety glasses and ear protection
3. Use protective clothing
4. Use protective gloves
5. Watch out for people in the tool operating range
6. Protect from rain
7. Disconnect before repair (maintenance)
8. Risk of fingers cut-off by rotating rotor blades
9. Keep a distance
10. Watch out for debris
11. Warning
12. For use outdoors
13. Do not touch moving parts of the machine
14. Do not allow children to the tool
CONSTRUCTION AND USE
The garden vacuum cleaner is a manual type device with Class II
insulation. It is driven by a single-phase AC commutator motor. The
garden vacuum cleaner is designed to perform three functions: blowing,
sucking, and shredding of the sucked-in garden waste such as leaves,
grass cuttings, small branches and other light debris around the
house and backyard garden. This device is not designed for industrial
applications and is only intended for use outdoors.
Use the tool according to its purpose only.
DESCRIPTION OF THE GRAPHIC PAGES
The enumeration below refers to the parts of the device shown in the
graphic pages of this manual.
1. Front suction tube
2. Suction tube lock button
3. Rear suction tube
4. Auxiliary handle
5. Shoulder strap eye
6. Speed control knob
7. ON/OFF switch
8. Main handle
9. Power cord holder
10. Release button
11. Collection bag handle
12. Operating mode lever
13. Collection bag
14. Roller wheel
15. Shoulder strap hook
16. Shoulder strap buckle
17. Shoulder strap
* The actual product may differ from the drawing.
11
3
4
5
8
9
10
STOP
13
14
Tabla de contenido
loading

Tabla de contenido