Kohler K-6356 Guia De Instalacion página 6

Copper
Tubing
Coupling
Nut
Compression
Fitting
5. Install the Supplies
NOTE: If the supply tubes need to be cut, allow for required
penetration of the tube into the supply stop.
NOTE: If the sink is not installed, install it at this time. Be sure to
follow all instructions packed with the sink.
Allow for required penetration of the supply tubes into the
supply stops.
Cut the supply tubes as needed.
Slide the coupling nut then the ferrule onto the copper tubing.
Set the compression fittings over the copper tubing.
Hand tighten the coupling nuts.
Slide the coupling nut then the ferrule onto each supply tube.
Set the compression fittings over the supply tubes.
Hand tighten the coupling nuts.
NOTE: Do not apply torque to the supply fittings at the bottom of
the faucet while installing or tightening the compression fittings.
Carefully bend the supply tubes to align them with the supply
stops.
Slide the coupling nuts and ferrules from the stops onto the
supply tubes.
1025491-2-C
Ferrule
Ferrule
Coupling
Supply Nut
Tube
6 Kohler Co.