Arbortech TURBO Shaft Manual De Instrucciones

The TURBOShaft is designed to complement the Arbortech TURBO range or as a stand alone tool, the TURBOShaft
TM
provides detailed freehand carving to perfectly combine efficiency and exceptional control.
The TURBOShaft TM is fitted with replaceable carbide teeth for excellent performance and durability even in the hardest
timbers. The adjustable depth gauge makes it easy to quickly set your cutting depth. The unique TURBOShaft
is a versatile addition to any woodworkers arsenal. Perfect for deep and narrow profiles, detailed sculpting, letterwork,
template work and more.
1
2
3
Side Handle
REPLACEABLE CARBIDE TEETH
TOP VIEW
6
TEETH CAN BE ROTATED TO A NEW
SHARP EDGE, OR REPLACED
DIAGRAM 2
Included with the TURBO Shaft
TM
1 x TURBO Shaft
1 x Depth Gauge
1 x Allen Key
1 x Torx TM key
For product support, please visit:
www.arbortechtools.com/support
MADE IN AUSTRALIA BY:
Arbortech Pty Ltd • 67 Westchester Rd • Malaga • Western Australia • 6090
Tel: +61 8 9249 1944 • Fax: +61 8 9249 2936
www.arbortechtools.com • Email: [email protected]
US Residents TEL Toll Free 866-517-7869 • US Fax 866-515-8104
Facebook.com/arbortechtools • Youtube.com/ArbortechWoodworking
4
DIAGRAM 1
5 7
TM :
SAFETY INSTRUCTIONS:
WARNING: Read and understand all safety warnings,
instructions, and tool markings before starting
any work. Failure to follow the instructions may
result in serious injury.
1. Keep work area safe, clean and well lit. Keep children and
bystanders away while operating the tool.
Use personal protective equipment
2 .
such as face shield, suitable safety gloves
and dust mask.
3. This tool must only be used on an angle grinder fitted with
an auxiliary side handle. Always use two hands to operate
the grinder and ensure that work piece is firmly secured.
(see Diagram 1 - side handle)
ASSEMBLY INSTRUCTIONS:
WARNING: Ensure grinder is unplugged from
power source before assembling or disassembling.
• Mounting of TURBO Shaft: (See Diagram 1)
Thread the Turbo Shaft (1) to the bottom of the Grinders Spindle (4).
Do not use any backing flange or spacers. A M14-M10 adaptor (3)
is supplied in some regions and can be used to mount the shaft on a
M10 x 1.5mm only spindle thread. The depth gauge (2) can be easily
adjusted to the required position or can be removed after loosening
the grub screw.
• Maintenance: (See Diagram 2)
Keep tool sharp, ensure cutter fixing screws (5) are firmly tightened with
the Torx TM Key (6) and check for possible damage before every use. The
cutting teeth (7) can be rotated to a new sharp edge after loosening the
fixing screws (5). Make sure you tighten the fixing screw after rotating or
replacing the tooth. Periodically loosen and re-tighten the screws even
without rotating the teeth, as the screws may bind up over time.
IND.FG.500
technology
TM
9 3 1 3 4 7 8 3 2 1 0 1 2
TM