Unpacking; Disposal Of The Packaging; Setup; Setup Location Requirements - Caso SA901-22 Manual Del Usuario

12.3 Unpacking

To unpack the device, remove the device out of the carton and remove the packaging
material.

12.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.

12.5 Setup

12.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
• The appliance must be positioned on a solid, even, horizontal and heat-resistant base
with sufficient load-supporting capacity for the appliance itself plus its heaviest content.
• Select an installation location where children cannot reach the appliance's hot surface.
• The appliance is not intended as a built-in appliance.
• Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
caso WineControl 25