Getting Started - Duux Twist Manual De Usuario

Getting started

Note: See Chapter 2 for the product
overview and references
Insert the plug into the wall socket.
1
Position the heater on a hard flat surface
2
at least 50cm away from the wall or any other
objects.
Turn the on/off switch on the back of the
3
appliance to the "on position", the fan heater is
now in stand-by mode
Press the "+ button" to turn on the appliance.
4
The fan will turn on and the position I
indicator will illuminate. The product does
not produce heat in this position.
Pressing the "+ button" again will set the fan
5
heater to the lowest setting. The
position II indicator will illuminate.
Pressing the "+ button" again activates the
6
highest heat setting, and the position III
indicator will illuminate.
Pressing the "- button" will reset the heat
7
setting.
8
To switch off the appliance, the "- button" must
8
be pressed up to 3 times (depending on the
starting position) until no indicators are
illuminated.
After switching off the heating setting, the fan
9
will remain on for ± 10 seconds to cool down
the heating element. After this, the appliance
automatically returns to the stand-by mode.
The air flow can be manually adjusted to the
10
desired angle. The appliance is tiltable by up
to 50 degrees. Turn the appliance by grasping
both sides and turning the appliance through
the left side. Do not touch the safety grid,
otherwise you may get burned.
If the appliance is not to be used for a long
11
period of time, we advise to switch the on/off
switch to position 0 and remove the plug
from the wall socket.