Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HOW TO OPERATE
Before making the first pot of coffee, wipe down the exterior of your RETRO SERIES™
12-CUP COFFEE MAKER with a clean, non-abrasive cloth or sponge. Thoroughly
wash the Filter Basket and Carafe in warm, sudsy water and thoroughly dry.
Next, find a flat surface near an electrical outlet. Make sure your cord is away
from any water source, then plug coffee maker into the electrical outlet.
Finally, follow the steps under the Brewing Coffee section using only water.
This will remove any dust or residue that remains in the system from the
manufacturing process. Discard the water and repeat if necessary.
Setting the Clock
1.
To set the current time, press the Pro button one time so the word
CLOCK is shown in the upper-right hand corner of the display.
2.
Press the Hour and Min buttons continuously until the display shows the correct time.
3.
Press the Pro button twice more to complete the set up and display the current time.
Brewing Coffee
1.
Open the Top Cover and fill the Water Tank with cold drinking water. Refer to the Carafe height
markings and fill to the desired amount of cups.
NOTE : Do not fill water past the MAX fill line located inside the Water Tank.
2.
Place a coffee filter into the Filter Basket, and add coffee grounds to the coffee filter.
Generally, it is recommended to use 1 tablespoon (1 Scoop) of ground coffee per cup, but the
amount used can be adjusted to your personal preference.
NOTE : This coffee maker requires the use of #4 size cone-shape coffee filters.
3.
Place the Carafe onto the warming plate and close the Top Cover.
4.
Press the I/O button. The Brew indicator light will illuminate red and begin the brewing cycle.
5.
When finished brewing, remove the Carafe to pour and serve coffee. Coffee will be kept warm
on the Warming Plate for 40 minutes. For your safety, the appliance will automatically turn off
after 40 minutes.
NOTE : The Carafe may be removed during the process of brewing and the appliance will
automatically stop dripping. DO NOT remove Carafe for more than 30 seconds at a time.
CAUTION : Freshly brewed coffee will be hot! Use
care when pouring and serving coffee.
6.
Turn off coffee maker by pressing the I/O button when finished using. Dispose of
the used coffee grounds and coffee filter. Filter Basket can be easily removed by
lifting the handle (found folded around the top perimeter of the Filter Basket).
Brewing Delay Function
1.
Begin by following steps 1-4 under Brewing Coffee.
2.
To set time for the brewing delay function, press the Pro button and the
word TIMER will show in the upper-left corner of the display.
3.
Set the desired brewing start time by pressing the Hour and Min buttons continuously.
4.
Press the I/O button twice and the Delay indicator light will illuminate green, indicating that
the brewing start time is set. After a few moments, the display will return to the current
time. You may check the brewing delay start time again by pressing the Pro button.
5.
When the current time reaches your selected brewing start time the Delay indicator light
will turn off, while the Brew indicator light will turn on and the brewing process will begin.
SNK100-IM.indd 33
EN
33
13/10/2016 15:06
Tabla de contenido
