Idiomas disponibles
Idiomas disponibles
GB
Setting up:
Before you can setup the stroller, you must open the safety lock (fig.1). Now extend
the framework of the stroller, until you can hear a latching sound (fig2). Then put
the rear axle onto the framework. You can check whether the axle has locked
securely, by pulling it.
To secure the front wheels push them onto the wheel suspension until you snap in
place audibly. After this push the rear wheel onto the axle until you can hear a
latching sound (fig.3). Make sure that the wheels are securely attached, by pulling
them lightly. For detachment of the rear wheel, push the button for unlatching
(fig.4) and pull the wheel from the axle.
Now put the piece for sitting onto both openings for receiving them at the frame-
work (fig.5 & 6), until you hear a click. You can check whether the piece for sitting
latched, by pulling it upwards slightly. The piece for sitting can be fastened in both
directions. For detaching the piece for sitting, push both grey buttons and lift the
seat from the framework (fig.7).
Swivel wheel function:
Fold the two plastic clips down in order to activate the swivel wheel function for the
two front wheels. In order to fix the front wheels, fold the two plastic clips back up
(see fig. 8a & 8b).
Operation of the breaks:
Push the bar for breaking downwards with your foot, in order to operate the breaks
(fig.9). By pulling upwards, you can release the breaks again (fig.10).
ATTENTION: When you stop the stroller, always operate the breaks.
Adjusting the footrest:
Press the two buttons on the right and left side (fig. 11) to move the footrest to the
desired position..
Adjusting the back rest:
In order to be able to adjust the position of the back rest, simply press the adjusting
mechanism down and adjust the back rest to the required position (fig. 12).
Attaching the canopy:
Insert the two plastic clips for the roof into the plastic slots in the right and left hand
side (fig. 13). Check whether the roof has slotted into place by pulling it upwards.
