SPX Johnson Pump AS888 Manual De Instrucciones página 5

Automatic Switch
AS888
Part No. 34-888
The automatic
switch protects
electrically operated
pumps and gives fully
automatic operation.
The switch is made of corrosion
resistant materials.
Max size: Width 75 mm, length
115 mm, height 95 mm.
Installation
Before installing float switch
AS888 form two ≈ 15 cm loops
of the wire and lock them in the
grooves in the base plate. Thus the
automatic float switch can move
with a minimum of resistance.
On a plate surface
Fix with two screws.
Ball at rest, switch in off mode.
Original instructions
OFF
ON
Water raises switch, ball rolls back,
switch snaps on.
With Johnson Pump
submersible bilge pumps
Johnson Pump submersible bilge
pumps have a T-slot on the hou-
sing or mounting bracket. You may
simply push the switch into place
onto the pump. If you wish, a small
drop of water-proof adhesive will
lock the switch on the T. Screws
are recommended for fastening
the switch only if your pump is not
equipped with a T-mount.
AS888 should always be instal-
led in parallel to the keel with the
floating body directed aft.
Never install AS888 at a level
lower than the inlet of the bilge
pump.
> english
5