Functional Description - Flexzilla L1388LFZ Instructivo Del Propietario

Important Safety Instructions for Charger:
• DANGER: Electrocution hazard! 120 volts are present at charger cord terminals. Do not probe with conductive objects. Electric shock
or electrocution may result.
• WARNING: Shock hazard. Do not allow any liquid to get inside charger. Electric shock may result.
• CAUTION: Burn hazard. To reduce the risk of injury, charge only Flexzilla 20V battery packs that fit the charger included with this tool.
Do not attempt to charge any other battery types with this charger. Other types of batteries may burst causing personal injury and
damage.
• CAUTION: Charger is intended for use indoors only. Do not expose charger to rain, snow, or frost. Do not place charger on any wet
surfaces. Do not place charger in any location where water may drip or splash on the charger or on the surface where the charger
rests.
• Pull the plug rather than the cord to remove from power supply connection. This reduces the risk of damage to the plug and cord. Do
not use charger or plug charger cord if cord or plug is damaged. Have damaged cord, plug, or strain reliever
replaced immediately. Do not attempt to repair power cord or plug.
• Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to stress or damage.
• Do not use extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock,
or electrocution. If an extension cord must be used, make sure the extension cord is properly wired and in good electrical condition.
The extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the
wire, the greater the capacity of the cable. For example, a 16 gauge has more capacity than 18 gauge cord.
For Total Length of Cord: 25 ft. (7.6m) to 50 ft (15.2 m) -- use 18 gauge minimum cord size.
• The charger is designed to operate on standard 120V AC electrical power. Do not attempt to use it on any other voltage.
• Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Replace the charger or
take it to an authorized service center.
DC .........................direct current
--- ...........................direct current symbol
V............................volts
Hz ..........................hertz
psi ..........................pounds per square inch (units of pressure)
- Model: L1388LFZ 20V DC Cordless Grease Gun
- Grease Reservoir Capacity: 14.5 oz. cartridge or 16 oz. bulk
- Lubricant (grease): Up to NLGI #2
- Battery Quick Charge: 1 hour charger

Functional Description

The Flexzilla 20V DC battery-powered, cordless grease gun allows convenient high-pressure greasing at grease pressures up to 7000
psi, utilizing a motor and set of gears to develop pressure for dispensing grease as a single-action, positive displacement pump. The
gun is operated (after grease-loading) by squeezing the trigger to dispense grease either freely from the grease nozzle (standard zerk
coupler) or by engaging the grease coupler onto standard grease zerk fittings on equipment and machinery for high-pressure greasing.
The gun is equipped with a pressure-relief valve to limit grease pressure to 7000 psi to reduce risk of motor overload, tool damage, and
to extend battery life. Additionally, an automatic bleeder valve bleeds trapped air in the grease barrel to make priming faster and easier.
Do not exceed specifications or alter gun to perform beyond ratings. Such misuse will void the warranty.
RAPID RELOAD PROCEDURE
1
Press to release barrel
Minimum Recommended Wire Size for Extension cords
75 ft. (22.9 m) to 100 ft (30.5 m) -- use 16 gauge minimum cord size.
125 ft. (38.1 m) to 150 ft (45.7 m) – use 14 gauge minimum cord size.
175 ft. (53.3 m) – use 12 gauge minimum cord size.
2
Symbols
AC..................alternating current
UL ..................Underwriter's Laboratories listing on charger
+ ....................Positive terminal on battery pack and charger
- .....................Negative terminal on battery pack and charger
UL745-3.........UL Standard for Safety for Battery-Operated Tools
Specifications
- Maximum Operating Pressure: Intermittent pressure: 7000 psi
- Battery Voltage: 20v max / 18v nominal
- Battery Capacity: 1500 milliamp hours
- Input Power Source: 120V AC
Slide barrel out to reload
3
Slide barrel back into head while
pressing the load button to re-engage