Source - Pioneer ELITE VSX-LX103 Manual De Instrucciones

„ Dolby
Change the setting of when Dolby signals are input.
Setting Item Default Value
Loudness On
Management
„ Volume
Change the Volume settings.
Setting Item Default Value
Mute Level -∞dB
Volume Limit Off
Power On Level Last
Headphone Level 0.0 dB
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the DRC function that allows you to enjoy
surround at low volumes is fixed to off when playing
Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"Off": When this function is not used
Setting Details
Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞dB",
"-40dB" and "-20dB".
Set the maximum value to prevent the volume
from becoming too loud. Select a value from "Off",
"-32 dB" to "+17 dB".
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "-∞ dB", and "-81.5 dB" to
"+18.0 dB".
• You cannot set a higher value than that of
"Volume Limit".
Adjust the output level of headphones. Select a
value between "-12.0 dB" and "+12.0 dB".
Contents Connections
≫

Source

„ Input Volume Absorber
Adjust the volume level when there are differences in volume level among
multiple devices connected to this unit. Select the input selector to make the
setting.
Setting Item Default Value
Input Volume 0.0 dB
Absorber
„ Name Edit
Set an easy name for each input. The set name appears on the main unit's
display. Select the input selector to make the setting.
Setting Item Default Value
Name Edit Input name
• To name a preset radio station, press TUNER on the remote controller, select AM/FM,
and select the preset number.
90
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Select a value between "-12.0 dB" and "+12.0 dB".
Set a negative value if the volume of the target
device is larger than the others and a positive
value if smaller. To check the audio, play back the
connected device.
• This function does not work in Zone 2.
Setting Details
1. Select a character or symbol with the cursors,
and press ENTER.
Repeat this operation to input up to 10
characters.
"A/a": Switches between upper and lower cases.
(Pressing MODE on the remote controller also
toggles between upper and lower cases)
"←" "→": Moves the cursor in the arrow direction.
" ": Removes a character on the left of the
cursor.
" ": Enters a space.
• Pressing CLEAR on the remote controller will
remove all the input characters.
2. After inputting, select "OK" with the cursors, and
press ENTER.
The input name will be saved.
≫