Adjusting The Handles - BOERBOEL GardDog Instrucciones De Instalación

(Step 2 Continued)
e.) Pre-drill holes and secure catch bracket with three
16mm Phillips self-drilling screws (Fig. 12).
f.) Slide the catch onto the bracket and position. The
removable spacer is attached to the front handle
base to ensure proper gap to engage the striker.
The gap between the catch and the front handle
base should be no less than
g.) Once you align the catch on the bracket, secure
its position with one 24mm Phillips machine screw.
Rotate the screw clockwise to decrease the gap, or
counter-clockwise to increase the gap (Fig. 14).

Adjusting The Handles

3
The handles are able to be positioned in a vertical or
horizontal orientation depending on your preference.
a.) Loosen the small screw under the shaft of the
handle (Fig. 15).
b.) Position the handle to desired orientation and
tighten the screw (Fig. 16).
⁄ ⁄ " (Fig. 13). ⁄ ⁄
1 1 1
8 8
Inside Inside
of Post of Post
Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer Removable Spacer
Front
Front
View View
Min 1/8" Min 1/8"
24mm 24mm 24mm 24mm 24mm
screw screw
Remove Remove
Screw Screw
Replace Replace
Screw Screw Screw Screw
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
5