Parts & Features - Pro Force L13HPF Manual Del Operador

Parts & Features
See figures below for reference
Air Intake Filter
Provides clean air to the pump
and must always be kept free
of debris. Check on a daily
basis or before each use.
Oil Fill Cap
Outlet
Tube
Oil Sight Gauge
Tank Drain Valve
Used to drain condensation
from the air tank. Located
at bottom of tank.
Regulator Gauge
Indicates the outgoing air
pressure to the tool and is
controlled by the regulator.
Pressure
Relief Tube
Quick Connect
Offers a quick release feature
for attaching and removing the
air hose.
3
Check Valve (not shown)
When the pump is not in
operation, the valve closes to
retain air pressure inside the tank.
Tank Pressure Gauge
Indicates the reserve air pres
sure in the tank.
Pressure Switch
This controls the power to the
motor and also the cut-in/cut-out
pressure settings. This switch
serves as the Auto-On/Off
positions for the unit.
Tank Safety Valve
Used to allow excess tank
pressure to escape into the
atmosphere. This valve should
only open when the tank
pressure is above the maximum
rated pressure.
Pressure Relief Valve
The pressure relief valve located
on the side of the pressure
switch, is designed to
automatically release
compressed air when the air
compressor reaches cut-out
pressure. The released air
should only escape momentarily
and the valve should then close.
Regulator
The air pressure coming from
the air tank is controlled by the
regulator. To increase the
pressure, turn the knob
clockwise, and to decrease
the pressure, turn the knob
counter clockwise.