Beltchanging And Agitator Cleaning; Bulb Changing; Agitator Servicing - Kenmore 116.21514 Manual De Uso

LIGHT BULB CHANGING
_IbWARNING
Electrical Shock Or Personal Injury
Hazard
Turn off and unplug vacuum cleaner
before performing maintenance to the
vacuum cleaner. Failure to do so could
result in electrical shock or personal
injury from the vacuum cleaner
suddenly starting.
NOTE: Use replacement bulb number 20-
5248, see part number detail in REPLACE-
MENT PARTS(page 6).
1. RemovePowerMate coveras shownin
BELTCHANGING AND AGITATOR
CLEANING
(page
23-24) section.
2. Remove the light
bulb by pulling
straight out.
_k CAUTION
Do not plug in or turn on until the vacuum
cleaner is completely reassembled._
Do not use a bulb rated over 9W (13V), !
During extended use, heat from the bulb J
Jcould overheat surrounding plastic ...... parts, I
3. To replace the
light bufb0 carefully
insert fully into slot,
4. Reinstall
PowerMate cover
as shown in BELT
CHANGING AND
AGITATOR CLEANING (page 23-24)
section.
AGITATOR SERVICING j
TO CHECK THE BRUSHES
iii iiii
,_ WARNING
Electrlcai Shock Or Personal Injury
Hazard
Always turn off and unplug vacuum
cleaner before performing maintenance
to the vacuum cleaner. Failure to do so
could result in electrical shock or personal
injury from vacuum cleaner suddenly
starting, .....
New Brushes
Worn Brushes
Base
Support
Bar
25
When brushes are worn to the level of the
base support bars, replace the agitator
assembly.
TO REPLACEAGITATOR
ASSEMBLY
1. Remove PowerMate cover, belt and
agitator assembly. See "To Remove Belt" in
BELTCHANGING AND AGITATOR
CLEANING (page 23-24).
2. Replace agitator assembly, See your
separate repair parts list for part number.
3. Reinstall belt and PowerMate cover. See
"To replace belt" in BELT CHANGING AND
AGITATOR CLEANING (page 23-24).