Level Adjustment - Scosche FAl-4 Guia De Inicio Rapido

WIRE CONNECTIONS (con't)
• Do not work with more than one wire at a time.
• All wires not referenced in illustrations must be capped or taped
off separately.
• Do not overtighten wire connectors.
• Optional black ground wire for noise suppression.
NOTE: Using the appropriate Scosche "Car Stereo Connector"
(available separately) to adapt to your vehicles wiring harness will
eliminate having to cut any of your factory wire.

LEVEL ADJUSTMENT

WARNING: IT IS IMPORTANT TO
SET ALL GAIN LEVELS AT MINUS(-) IN
ORDER TO PROTECT YOUR SYSTEM. C\
ONLY ADJUST THE PODS APPLICA-
BLE TO YOUR INSTALLATION.
FOR EXAMPLE: For adding an
aftenmarl<et stereo to factory system you
will only adjust "factory amp gain" controls.
CAUTION: GAIN CONTROL ADJUSTMENTS ARE FRAGILE,
DO NOT FORCE. A SUGHT ADJUSTMENT WILL CHANGE
VOLUME DRAMATICALLY. TO PREVENT DAMAGE DO NOT
PRESS DOWN WHILE ROTATING LEVEL CONTROLS.
TO ADJUST:
1. Turn STEREO on and adjust the volume to about 3/4 of the
stereo's maximum volume.
2. Carefully turn the four (4) gain controls up (by turning them
clockwise from minus position) on the FAl-4 until the sound
is just above your nonmal listening volume or near distortion.
Distortion is when the sound/music breaks up, becomes
garbled, or unclear.
3. All four (4) gain adjustments should be set at the same level.
(Gain needs to be turned in the same direction.)
4. If there is excessive HUM or HISS between songs, the gain
levels are set TOO HIGH and should be turned down (back
toward minus).
NOTE: LEVEL ADJUSTMENTS APPLY
TO ALL ILLUSTRATIONS!
f9
0
0
+