MORDOMUS TRUE IOT iSFTH1 Manual De Instrucciones

iSFTH1
EN
iSFTH1 – Wi-Fi 1 ch relay ON/OFF
Features:
• 1 relay output.
•
Interface with optional external humidity and temperature sensor
AM2301 (not included).
Applications:
•
1 relay output for illumination, switching of sockets, heating, boilers,
motors, lighting, switching of loads in general.
•
Temperature and humidity reading (by external sensor).
Electrical Specifications:
Power supply voltage: 90-250VAC
Power supply frequency: 50/60Hz
Max output current: 16A
Wireless standard: Wi-Fi 2.4GHz
Physical Specifications:
Dimensions: 53mm X 32mm X 115mm.
Protection degree: IP20, for indoor use.
iSFTH1
http://mordomus.com/m
ordomus/docs/wifi/iSFT
H1.pdf
ATTENTION:
Mordomus shall not be liable for any damages resulting from the
use of our equipment outside the specifications and/or for a purpose
other than that intended.
Do not exceed the output ratings.
Overview:
Push-button for configuration
Connection status indicator
Screw holding terminal cover.
Temperature and humidity sensor port for AM2301.
1. Installation
Caution! Before installing the device, make sure that the mains power
is turned off.
1. Turn off mains power.
2. By means of a PH2 screwdriver remove the screw and the terminal cover.
3. Perform the connection according to the schematic.
4. Place the terminal cover again and tighten the screw.
5. If applicable, connect the external sensor AM2301 to the sensor port
6. Power up.
2. Connection to WI-FI network and enrollment to Mordomus
Method 1 - Automatic Setup (Router must support WPS)
1. Since factory, on powering up the iSFTH1 is in WPS negotiation mode
signaled by the connection status indicator blinking fast continuously.
Take care not to power up more than one iSFXX or iSHXX device at the
same time since WPS allows for configuration of only one device at a
time. We recommend powering up and registering the devices in a sequential
manner.
2. Press the WPS button on the router according to the user manual of this
device and wait until the WPS negotiation is completed. This is signaled by 2
short blinks of the connection status indicator every 2 seconds.
3. Activate the pairing mode in the Mordomus Software by clicking the Start
inclusion button in the device registration menu.
To reach this menu from the main screen click Configurations → Modules/
Addresses → Plus Button [+]
This mode is limited to 5 minutes in software and on the iSFTH1 device for
safety reasons.
4. After the iSFTH1 device shows up in the list make sure to click the button
Allow.
The connection status indicator should remain off.
From now on the iSFTH1 device is ready to use.
Method 2 - Manual Setup
1. Activate AP mode and access the configuration page as described in section
5.
2. Enter the (SSID) in the field WiFi Name and password WiFi password. Enter
v.1927
.
1/6